KNOWING YOUR CAR -> BOOT for Your Fiat 500 SUV Second Generation (2020-2025)

least 30 seconds (to force the loss of  
initialisation);  
re-position the backrest correctly; the  
Wind Stop is locked between the seat  
and parcel shelf.  
keep the closing button pressed until  
the soft top is completely closed;  
once the all closed position has been  
reached, continue to press the button  
until the soft top makes a full opening  
and closing run.  
FRONT SPOILER  
The car is provided with a front spoiler  
which can be raised to improve  
aerodynamic comfort inside the  
passenger compartment.  
WIND STOP  
To lift the spoiler, release the catch  
by means of the slider (A) moving it to  
position (2) as shown in fig. 64  
With the spoiler raised, take care not to  
move the slider (A) from position (1) to  
position (2).  
65  
F0S1320  
The Wind Stop fig. 63 is designed to  
improve driving comfort, by reducing  
air turbulence in the passenger  
compartment when travelling with the  
soft top down.  
It is advisable to raise the spoiler when  
the horizontal segment of the top  
is open and at speeds faster than  
50 km/h.  
To use the Wind Stop fig. 63:  
With the top completely open, it is  
advisable to keep the spoiler lowered  
to limit wind noise inside the passenger  
compartment.  
1
Raising the spoiler will reduce the flow  
of air to the rear seats.  
2
A
WASHING/CLEANING  
THE SOFT TOP  
18) 19) 20) 21) 22) 23) 24) 25)  
64  
F0S1319  
63  
F0S1318  
Use of specific products is  
recommended for washing the soft top  
cloth.  
To lower the spoiler, press and move  
the slider to position fig. 65 to lock it  
once the slider’s catch is positioned  
inside its housing (1) fig. 64.  
Release the backrest of the rear seat  
(single or split).  
The soft top fabric is treated with a  
special water-repellent, waterproof  
product. The water-repellent properties  
will degrade in time with exposure to  
the weather elements. Observe the  
following instructions.  
Attach the Wind Stop by inserting  
the central part inside the rear screen  
guard, with the concave part in the  
direction of the passenger, as shown in  
fig. 63;  
62  
Remove as much dirt from the surface  
of the soft top with a soft brush or  
vacuum cleaning before washing  
it. This operation will considerably  
improve the final result.  
Use common, care mild stain removers  
that can be purchased from car  
cleaning product ranges to remove  
more stubborn stains. Apply by blotting  
(never rubbing) directly on the area of  
the stain.  
18) Bird droppings and plant resins must  
be washed off immediately and thoroughly  
from the soft top as the acid they contain  
is particularly aggressive.  
19) Never use high-pressure washing  
systems.  
In lack of specific products, use water  
and neutral soap applied with a sponge  
(preferably in the shade) for washing.  
Rinse the soft top with clean water after  
having eliminated all the stains.  
Hand washing is recommended;  
modern automatic washing systems  
equipped with soft brushes which  
do not apply excessive pressure and  
employ specific soft top products may  
be used.  
20) When using steam washers or  
high-pressure water washers, maintain  
a suitable distance and do not exceed a  
maximum temperature of 60°C. Damage,  
alterations and water infiltration may  
occur if the distance is too small and the  
pressure is too high.  
21) If a water jet is used, direct away  
from the edges of the fabric and the rear  
window frame to prevent water infiltration.  
22) Never use alcohol, petrol, chemical  
products, detergents, stain removers, wax,  
solvents and "wash and polish" products.  
23) Rinse immediately to remove soap  
to prevent stains. Repeat the operation if  
needed.  
24) Follow the instructions on the  
waterproofing product container for  
perfect results.  
25) The rubber seals on the soft top  
must be cleaned exclusively with water.  
If you notice that this trim is dry or is  
sticking, apply talcum powder or products  
specifically for rubber trim (silicone spray).  
IMPORTANT  
32) Keep hands away from the top  
mechanism while opening and closing the  
top or if the top stops in a position before  
completing the cycle to prevent damage  
and injury.  
33) Keep children away from the area in  
which the top is folding during opening or  
closing operations.  
34) When leaving the car, turn the ignition  
device to STOP and always take the  
electronic key with you to avoid the risk of  
injury due to accidental operation of the  
soft top. Improper use may be dangerous.  
Before and during operation, always check  
that no-one is at risk of being injured by  
the moving soft top or by objects getting  
caught and dragged by it.  
Leave the car in the shade after  
washing avoiding direct sunlight.  
Waterproofing the soft top  
Use specific waterproofing products for  
fabric soft tops.  
Interior soft top fabric  
Remove dust with a soft brush. Avoid  
using hard brushes made of synthetic  
material to prevent damaging the fabric  
beyond repair.  
WARNING  
Clean the surface with a microfibre  
cloth or soft sponge dipped in a  
solution of water and neutral soap.  
Clean the entire surface, including the  
zones where cleaning is not needed, to  
prevent staining.  
15) Never open the top in presence of  
snow or ice to prevent damage.  
16) Do not place objects on the rear  
window shelf to prevent damage while the  
top is closing.  
17) Loads may not be secured on the roof.  
63  
BOOT  
fig. 59 if a valid key is detected near the  
rear of the car.  
35) 36)  
A handle (B) fig. 67 is provided inside  
the tailgate to make it easier to close.  
ELECTRIC HANDLE  
(SOFT TOUCH)  
The tailgate can be opened at any time  
if the doors are unlocked.  
To open it, enable the handle, opening  
one of the front doors or unlocking the  
doors with the remote control.  
Operate the electric handle (F) fig. 66  
to open the tailgate.  
66  
F0S1440  
Opening the tailgate with soft top  
all open  
To release the lock with the remote  
.
Pressing the tailgate opening one-  
touch button (F) fig. 66 to automatically  
close the soft top to spoiler position.  
The tailgate can be opened in spoiler  
position.  
control, press button  
67  
F0S1332  
For cars with the Passive Entry  
system, even if the doors are locked,  
the boot can be opened using the  
electric handle (F) with a valid key  
detected near the rear of the car.  
To close, use the handle located  
inside the tailgate.  
If the tailgate is not shut properly the  
dedicated instrument panel or colour  
display warning light (where provided)  
will switch on.  
EMERGENCY TAILGATE  
OPENING  
To open the tailgate from the inside if  
the 12V battery in the car is flat or the  
electric lock on the tailgate is faulty,  
proceed as follows:  
WARNING It is not possible to open  
the boot if the soft top has not been  
initialised. Carry out the soft top  
initialisation procedure as described in  
the section "Initialisation procedure" in  
the chapter "Soft top" in this section.  
take out the rear head restraints;  
tilt the backrests;  
to unlock the tailgate mechanically,  
working from the inside of the boot,  
remove the protective yellow cap and  
then use lever (A) fig. 68.  
CLOSING  
To close, lower the tailgate by pressing  
near the lock until you hear it click.  
For cars equipped with the Passive  
Entry system, the boot and all doors  
can be locked with the button (G)  
64