KNOWING YOUR CAR -> DOORS for Your Fiat 500 SUV Second Generation (2020-2025)

occurred in system operation: in this  
case, contact a Fiat Dealership.  
Locking doors without alarm insertion  
is also always possible by locking the  
doors through the emergency locking  
procedure. For more information see  
"Emergency opening and closing" in  
the "Doors" chapter.  
the "Passive Entry" paragraph in the  
"Doors" chapter.  
In any case, the doors can be locked  
by pressing the button (A) on the  
centre dashboard. The LED on the  
button will light up to notify the locking.  
With doors locked, press the button  
again to unlock them. The LED on  
the button will go out to notify the  
unlocking.  
DISARMING THE ALARM  
To completely deactivate the alarm  
(e.g. during a long period of car  
inactivity), close the doors using the  
emergency locking manoeuvres  
described in the "Doors" chapter.  
WARNING If the doors are unlocked by  
putting the metal insert into the driver  
side door lock, the alarm, if previously  
enabled, is not disabled. It will be  
possible to disable the alarm by turning  
the ignition device switch to ENGINE,  
or by pressing button on the remote  
control.  
WARNING If the batteries of the key  
with the remote control run out or the  
system fails, the alarm can be switched  
off by placing the ignition device switch  
in the ENGINE position.  
DOORS  
LOCKING / UNLOCKING  
DOORS FROM THE  
INSIDE  
16  
F0S1098  
TURNING THE ALARM  
OFF  
Opening the door  
Central locking / unlocking  
The door can be opened by pressing  
the button (B) fig. 17 located above  
each door. If the function is present,  
pressing the button on either door  
opens the door and unlocks the other  
doors and the boot. The function must  
have been activated via the instrument  
panel display menu or the Uconnect™  
system (see "Settings" in the "Vehicle  
mode" paragraph in the "Multimedia"  
section).  
Press the button. The following  
operations are performed:  
two brief flashes of the direction  
indicators (where provided);  
two brief acoustic signals (where  
provided);  
Where provided, the "Autoclose"  
function automatically activates the  
automatic locking of the doors on  
exceeding the speed of 20 km/h. If it is  
not present, use the respective control  
(A) fig. 16 located on the centre  
dashboard to lock/unlock the doors.  
Where provided, the "Autoclose"  
function can be activated/deactivated  
via the Uconnect™ system (see  
"Doors & Locks" in the "Vehicle Mode"  
paragraph in the "Multimedia" section).  
doors are unlocked.  
For versions with Passive Entry  
function, the alarm can be switched  
off by the key holder by pressing the  
door opening button on the external  
handle. For further information, see  
27  
be locked and cannot be opened from  
outside any more.  
to facilitate access to the rear seats  
and getting out of the car. See the  
"Seats" chapter in this section for more  
information.  
Door unlocking from the outside  
Press the opening button on the  
key. Then pull the handle (E) fig. 19 on  
one of the two doors to enter the car.  
IMPORTANT The front passenger seat  
belt is fitted on the rear door. If the  
seat belt of the front seat passenger  
is fastened, it must be unfastened and  
fully retracted it before opening the rear  
door.  
VERSION "3+1" -  
OPENING/CLOSING  
THE REAR DOOR ON  
PASSENGER SIDE  
(where provided)  
17  
F0S1099  
IMPORTANT The front seat passenger  
must always make sure the door is  
closed before fastening the seat belt.  
Press button (B) fig. 17 three times  
in two seconds to open the door in  
motion at speeds above 5 km/h (to  
prevent spontaneous opening of the  
door while in motion). At speeds below  
5 km/h, the door will open when the  
button is pressed for the first time. The  
red LED around the button will light up  
when the door is locked and it will turn  
off when the door is unlocked.  
Opening  
To open the rear door on passenger  
side, firstly open the respective front  
door using handle (E) fig. 19 (opening  
from the outside) or button (B) fig. 17  
(opening from the inside).  
Closing  
Close the rear door first and then the  
front door.  
PASSIVE ENTRY  
4)  
Then open the rear door using the  
internal handle (A) fig. 18.  
The Passive Entry system can identify  
the presence of an electronic key near  
the doors.  
LOCKING / UNLOCKING  
DOORS FROM THE  
OUTSIDE  
The system lets you lock/unlock the  
doors (and the tailgate) without having  
to press any button on the electronic  
key.  
A
Locking from the outside  
With the doors closed, press the  
button on the key.  
If the system identifies the electronic  
key detected outside the car as a valid  
one, the key holder can simply pull the  
handle (E) fig. 19 on one of the two  
doors to deactivate the alarm and open  
the door. The other doors and the boot  
will be unlocked.  
The door lock can be activated also  
with all doors open and the boot open.  
When the button on the key is  
pressed, all the locks are closed,  
including that of the open boot. When  
the open door or boot is closed, it will  
18  
F0S1339  
NOTE It is recommended to fold  
the front passenger seat forward  
28  
WARNING After pressing the "door  
locking" button (B) , you need to wait  
two seconds before the doors can  
be unlocked again using the door  
handle (E). It is therefore possible  
to check whether the car is locked  
correctly by pulling the door handle  
within 2 seconds. The doors will not be  
unlocked again. The doors and tailgate  
of the car can still be locked from the  
Once all the doors are closed, the  
FOBIK-Safe system performs a check  
inside and outside the car to verify the  
presence of enabled electronic keys.  
If one of the electronic keys is detected  
inside the car and no other active  
electronic key is detected outside  
the car, the FOBIK-Safe function  
automatically unlocks all the car doors.  
The FOBIK-Safe function will also  
intervene if the electronic key is left  
inside the boot. When the boot is  
closed, if the electronic key is detected,  
the system will unlock the boot.  
19  
F0S1100  
outside by pressing the button  
on  
the electronic key or from the inside by  
pressing the (A) fig. 16 placed on the  
centre dashboard.  
If the function is present, by pressing  
the button on the driver's door it is  
possible to open the driver's side door  
only, leaving the other doors and the  
boot locked, or to open the driver's  
side door by unlocking the other doors  
and the boot according to the mode  
set using the display menu on the  
Uconnect™ system (see "Settings" in  
the "Vehicle mode" paragraph in the  
"Multimedia" section).  
If, on the other hand, one or more  
electronic keys are found inside the  
passenger compartment, locking the  
doors with another key will disable the  
operation of the keys from the inside.  
In this case, the FOBIK-Safe function  
will not detect the disabled keys if  
left inside the car. To re-activate their  
correct operation, press the button  
on the remote control.  
PREVENTION AGAINST  
INADVERTENT LOCKING OF  
THE KEY INSIDE THE CAR  
(FOBIK-SAFE)  
The key is provided with an automatic  
door unlocking function to avoid leaving  
the electronic key inside the car  
accidentally.  
Door locking  
To lock the doors, proceed as follows:  
make sure that you have the  
There are three situations that activate  
the FOBIK-Safe system:  
NOTES  
A lock request made with a valid  
electronic key while the door is open.  
A lock request made by pressing the  
door lock button on the outside handle  
(B) fig. 19 while a door is open.  
A lock request made by pressing  
the door lock button (A) fig. 16 on the  
centre dashboard while a door is open.  
electronic key and are close to the  
driver's or the passenger's door;  
press the button (B) fig. 19 on the  
handle: this will lock all doors and the  
tailgate. Locking the doors will also  
activate the alarm (where provided).  
The car will not unlock the doors  
if one of the following situations is  
present:  
the doors have been locked by  
means of the emergency lock using the  
door opening button (B) fig. 17 on the  
door panel;  
29  
detected inside when it is locked, the  
tailgate will unlock again and the lights  
flash twice.  
an electronic key close to the car has  
been detected outside.  
It thereby prevents the opening of  
the doors from inside the passenger  
compartment, serving as an obstacle  
to break-in attempts.  
Access to the boot  
If the car is provided with Passive  
Entry function, while approaching the  
tailgate with an enabled electronic key,  
press the electric door opening button  
located under the handle (F) fig. 20,  
grasp this last and lift the boot tailgate.  
We recommend that you activate the  
device each time you park your car.  
WARNING Before driving make sure  
the tailgate is closed correctly.  
Activating the device  
The device is activated on all doors by  
Locking the doors using button on  
boot  
(where provided)  
pressing button  
on the key twice  
in rapid succession or, for cars with  
Passive Entry, by pressing the lock  
button on the exterior handle of the car.  
The direction indicators flash 3 times to  
let you know that the device is active.  
If one or more of the doors are not  
closed correctly, the device will not  
activate, thus preventing a person from  
getting stuck inside the passenger  
compartment by entering the car  
through, and then closing, the open  
door.  
If the system identifies a valid electronic  
key on the outside of the car, by  
pressing the button (G) fig. 20 the  
tailgate can be locked with all doors  
and the boot itself.  
WARNING Boot opening is disabled  
while the car is moving.  
20  
F0S1102  
System activation/deactivation  
The Passive Entry system can be  
activated/deactivated using the display  
menu or on the Uconnect™ system  
(see "Settings" in the "Vehicle mode"  
paragraph in the "Multimedia" section).  
WARNING Where provided, the alarm  
system will be temporarily disabled  
only for the boot area. After closing  
the boot, the alarm system will be  
reactivated again.  
Deactivating the device  
The device disengages automatically:  
when the doors are unlocked  
(pressing button on the key with  
remote control);  
when the ignition device is set to  
ENGINE;  
by pressing the door opening button  
on the outside handle in the case of a  
car equipped with the Passive Entry  
system.  
DEAD LOCK DEVICE  
(where provided)  
For vehicles not equipped with a  
Passive Entry system, use the remote  
control to open the boot.  
14)  
This safety device inhibits the operation  
of the interior buttons of the car and  
the door lock/unlock door button.  
WARNING With the car locked, if the  
tailgate only is unlocked, if a key is  
30