Get KNOWING YOUR CAR -> SEATS Guide for Fiat 500 SUV Second Generation (2020-2025)

detected inside when it is locked, the

tailgate will unlock again and the lights

flash twice.

an electronic key close to the car has

been detected outside.

It thereby prevents the opening of

the doors from inside the passenger

compartment, serving as an obstacle

to break-in attempts.

Access to the boot

If the car is provided with Passive

Entry function, while approaching the

tailgate with an enabled electronic key,

press the electric door opening button

located under the handle (F) fig. 20,

grasp this last and lift the boot tailgate.

We recommend that you activate the

device each time you park your car.

WARNING Before driving make sure

the tailgate is closed correctly.

Activating the device

The device is activated on all doors by

Locking the doors using button on

boot

(where provided)

pressing button

on the key twice

in rapid succession or, for cars with

Passive Entry, by pressing the lock

button on the exterior handle of the car.

The direction indicators flash 3 times to

let you know that the device is active.

If one or more of the doors are not

closed correctly, the device will not

activate, thus preventing a person from

getting stuck inside the passenger

compartment by entering the car

through, and then closing, the open

door.

If the system identifies a valid electronic

key on the outside of the car, by

pressing the button (G) fig. 20 the

tailgate can be locked with all doors

and the boot itself.

WARNING Boot opening is disabled

while the car is moving.

F0S1102

System activation/deactivation

The Passive Entry system can be

activated/deactivated using the display

menu or on the Uconnect™ system

(see "Settings" in the "Vehicle mode"

paragraph in the "Multimedia" section).

WARNING Where provided, the alarm

system will be temporarily disabled

only for the boot area. After closing

the boot, the alarm system will be

reactivated again.

Deactivating the device

The device disengages automatically:

when the doors are unlocked

(pressing button on the key with

remote control);

when the ignition device is set to

ENGINE;

by pressing the door opening button

on the outside handle in the case of a

car equipped with the Passive Entry

system.

DEAD LOCK DEVICE

(where provided)

For vehicles not equipped with a

Passive Entry system, use the remote

control to open the boot.

14)

This safety device inhibits the operation

of the interior buttons of the car and

the door lock/unlock door button.

WARNING With the car locked, if the

tailgate only is unlocked, if a key is

The horn is still active even when the

ignition device is in the OFF position.

Opening and locking

doors in the event of

power failure

pawl (A) fig. 21 using the key inside the

remote control.

EMERGENCY CLOSING

AND OPENING

If the 12V battery of the car is flat, the

doors can still be opened or locked as

they are equipped with an additional

power supply.

If the electronic key does not work, e.g.

if the battery of the key is low, you can:

unlock the car using the mechanical

key inside the electronic key by acting

on the pawl located on the driver's

door. See the "Emergency opening

of the doors from outside" paragraph

below.

Opening the doors

You can open the door in the following

ways:

with the doors locked, press the

door opening button (E) fig. 19 on the

external handle three times within 2

seconds.

Turn the pawl (C) placed on

the driver's door fig. 24 using the

mechanical key located inside the

electronic key.

F0S1195

Lock the car by pressing the door

open button (B) fig. 17 placed on the

inner door panel for about 5 seconds

keeping the ignition device in STOP

position and the door open.

Emergency opening of the doors

from the inside

If the electronic key does not work,

for example if the electronic key or the

12V battery of the car is low, the doors

can still be opened from the inside by

pulling the emergency lever (D) fig. 22

located on each door.

The car will lock all the doors and the

tailgate after about 5 seconds.

The LED on the door button (B) fig. 17

and on the centre dashboard (A) fig. 16

will light up to notify the locking.

When the last door is closed the car will

be locked.

Press the internal door opening

button three times (B) fig. 17 in two

seconds.

Locking the doors

The doors can be locked following the

emergency locking manoeuvre. See

the "Emergency closing and opening"

paragraph described above.

The car can be locked from any door,

respecting the manoeuvre described

above.

NOTE See the "Emergency closing and

opening" paragraph described above.

RESET

Resetting the door is automatic for a

certain number of times after which

it must be done manually using the

F0S1101

Emergency opening of the doors

from the outside

the keys inside the car. The emergency

locking manoeuvre disables the FOBIK-

Safe function.

If the electronic key does not work

(e.g. if the battery of the electronic

key is low) or if the power supply fails

completely, you can still open the

doors from the outside by proceeding

as follows:

SEATS

FRONT SEATS

15) 16)

remove the cap (B) fig. 23 present on

the external handle on the driver's side

inserting the mechanical key inside the

electronic key in the slot (A);

F0S1282

Longitudinal adjustment

Lift lever (A) fig. 25 and push the seat

forwards or backwards: in the driving

position, you should be able to rest

your arms on the steering wheel rim.

IMPORTANT

14) By engaging the Dead Lock device it is

possible to open the doors from inside

the car only by acting on the emergency

handle (D) fig. 22. Therefore, make sure

that there is no-one on board before

getting out.

WARNING

F0S1281

4) The operation of the recognition system

depends on various factors, such as,

for example, any electromagnetic wave

interference from external sources (e.g.

mobile phones), the charge of the battery

in the electronic key and the presence of

metal objects near the key or the car. In

these cases it is still possible to unlock

the doors by using the metal insert in the

electronic key (see description on the

following pages).

open the door using the mechanical

F0S1103

key (A) inside the electronic key by

turning the pawl anticlockwise (C)

fig. 24 on the outside handle on the

driver's side.

17)

Height adjustment

(for versions/markets, where provided)

Operate lever (B) fig. 26 to lift or lower

the rear part of seat to achieve the

most comfortable driving position.

5) After locking the car by emergency

manoeuvre, make sure you do not leave

KNOWING YOUR CAR -> SEATS for Your Fiat 500 SUV Second Generation (2020-2025)

Related Topics

KNOWING YOUR CAR

Popular Owner Manuals

Latest Owner Manuals