KNOWING YOUR CAR -> ROOF for Your Fiat 500 SUV Second Generation (2020-2025)

This device is also useful if the windows  
are activated accidentally by children  
on board the car.  
by personal objects getting caught in the  
mechanism or by being hit by it directly.  
29) When leaving the car, always set the  
ignition device in the STOP position and  
take the electronic key with you to avoid  
the risk of injury of people still on board  
due to accidental operation of the power  
windows.  
30) If the anti-pinch protection intervenes  
three consecutive times in one minute or  
is faulty, the automatic closing operation  
of the window is inhibited, only allowing it  
in "steps"; the button is released for the  
subsequent manoeuvre. In order to restore  
the correct operation of the system, the  
respective window must be wound down.  
The anti-pinch safety function is  
activated both during the manual and  
the automatic operation of the window.  
When the anti-pinch system is  
activated the window travel is  
immediately interrupted. Then the  
window stroke is automatically  
inverted.  
A
54  
F0S1269  
SUNROOF  
(where provided)  
31)  
30)  
ELECTRIC WINDOWS  
SYSTEM INITIALISATION  
If power supply is interrupted when  
the window is moving, the electric  
window automatic operation must be  
reinitialised. The initialisation procedure  
described below must be carried out  
with the doors closed and for each  
door:  
12) 13) 14)  
ROOF  
To move the sunshade, follow the  
instructions in “fixed glass roof”.  
FIXED GLASS SUNROOF  
(where provided)  
Opening  
The roof comprises a wide fixed  
glass panel and a manually-operated  
sunshade. The blind can be used in the  
"all closed" or "all open" positions.  
To open the blind, grab the handle,  
press the tooth (A) fig. 54 and move it  
to the completely open position.  
To close it, grab the grip and move the  
blind to the closed position until catch  
(A) is attached.  
Press button (A) located near the front  
ceiling light pressed fig. 55, to move  
the roof to “vent” position. With the roof  
open in “vent” position, hold button (A)  
pressed again to move the roof to all  
open position.  
fully close the window to be  
initialised, with manual operation;  
after the window has reached the  
upper end of travel, hold the up button  
down for at least 3 seconds.  
IMPORTANT  
28) Improper use of the electric windows  
can be dangerous. Before and during their  
operation, ensure that any passengers are  
not at risk from the moving glass either  
57  
after full closing, wait for the sunroof  
motor to stop.  
IMPORTANT  
EMERGENCY OPERATION  
If the electrical device for moving the  
roof fails, the sunroof can be moved  
manually proceeding as described  
below:  
31) When leaving the car, make sure  
to take the key with you to avoid the  
risk of injury to those still inside the  
car due to accidental operation of the  
sunroof. Improper use of the roof can be  
dangerous. Before and during operation,  
always check that no-one is exposed to  
the risk of being injured by the moving  
sunroof or by objects getting caught or hit  
by it.  
A
B
55  
F0S1330  
Closing  
Press button (B) fig. 55 from the all  
open position: the front glass panel will  
move into the “vent” position. Press  
button (B) again to reach the all closed  
position of the roof.  
WARNING  
12) You are advised to use the sunroof  
only at "vent" position if a transverse roof  
rack is fitted.  
13) Do not open the sunroof if there is  
snow or ice on it: you may damage it.  
14) Be careful not to hit objects on the roof  
rack when you open the tailgate.  
56  
F0S1331  
ANTI-PINCH DEVICE  
The sunroof has an anti-pinch safety  
system capable of detecting the  
presence of an obstacle whilst the roof  
is closing. When this happens, the  
system stops and the movement of the  
roof is immediately reversed.  
for manual activation remove the  
protective cap (A) fig. 56 from its  
housing which is located on the internal  
covering behind the sunshade  
take the hex wrench provided from  
the tool bag in the boot  
insert the key provided into housing  
(B) fig. 56and turn it clockwise to open  
the roof or anticlockwise to close the  
roof.  
INITIALISATION  
PROCEDURE  
The sunroof must be reinitialised after  
disconnecting the 12V battery or if the  
corresponding protective fuse is blown.  
Proceed as follows:  
keep the button (B) fig. 55 pressed  
so that the roof closes completely in  
stages  
58