Get KNOWING YOUR CAR -> INTERIOR FITTINGS Guide for Fiat 500 SUV Second Generation (2020-2025)

it from opening while the vehicle is

travelling.

INTERIOR FITTINGS

STORAGE

COMPARTMENTS

40)

IMPORTANT

Lower compartment

37) Be very careful not to allow scarves,

neck ties and other loose articles of

clothing from touching, even accidentally,

any moving parts. This may cause the

clothing to be pulled into the part, resulting

in serious risk to the wearer.

To open the bottom drawer, pull the

lever (A) fig. 72. The flap opens down

automatically.

F0S1131

38) For safety reasons, the bonnet must

always be properly closed while driving.

Therefore, make sure that the bonnet

is properly closed and that the lock is

engaged. If you discover that the bonnet

is not perfectly closed while driving, stop

immediately and close the bonnet in the

correct manner.

39) Use both hands to lift the bonnet.

Before lifting, check that the windscreen

wiper arms are not raised from the

windscreen, that the car is stationary and

that the electric parking brake is applied.

WARNING On both sides of the

passenger side sun visor there is a

label advising that it is compulsory to

deactivate the airbag if a rear facing

child restraint system is fitted. Always

comply with the instructions on the sun

visor (see the "Supplementary Restraint

System (SRS) - Airbag" chapter in the

"Safety" section).

F0S1130

SUN VISORS

They are located at the sides of the

interior rear-view mirror (fig. 73).

They can be adjusted forwards and

sideways.

USB INPUT

(where provided)

The car can be equipped with three

USB ports. The port located on

the dashboard ((A) fig. 74) for data

transfer to the Uconnect™ system

and for charging external devices, the

USB port inside the central console

((B) fig. 75) and on the dashboard,

next to the smartphone holder (where

provided) (D) fig. 76 for charging

external devices only.

To direct the visor laterally, detach the

visor from the interior rear-view mirror

side support and turn it towards the

side window.

Courtesy mirrors are located on the

back of the sun visors.

WARNING After using a USB charging

port, we recommend disconnecting the

device (smartphone), always removing

the cable from the port of the car first,

never from the device. Cables left

flying or connected incorrectly could

compromise correct recharging and/or

the USB socket condition.

NOTE The USB port handles

data transmission from the Pen

Drive/Smartphone, etc. and slow

recharging of an external device, which

is not guaranteed as it depends on the

device type/brand.

F0S1137

F0S1132

F0S1228

F0S0844

On versions provided with "smoker's

kit" optional equipment, the cigar lighter

is fitted instead of the power socket.

WARNING Do not connect devices

with powers higher than 180W to the

socket. Do not damage the socket by

using unsuitable adaptors.

POWER SOCKET

(for versions/markets where provided)

This is located on the central console

and only works with the ignition device

in the ENGINE position. To use it, open

cap (C) fig. 75.

COMPARTMENT ON

CENTRAL TUNNEL

An additional D power socket (D) fig. 77

located in the luggage compartment is

available on some versions.

F0S1133

In the central tunnel there is a storage

compartment. To access it, grab the

handle (A) fig. 78 and push the cover

back. A second USB port is provided

inside the compartment on some

versions.

To access the front cup holder/can

holder open the door using the handle

(A) fig. 80.

to turn volume up or down of the

Uconnect™system. A short press on

the control mutes the system, a long

press turns it off.

(B)- e-MODE. push or pull the lever

to select the different driving modes

(NORMAL, RANGE, SHERPA).

FRONT ARMREST

(where provided)

F0S1134

F0S1136

SMARTPHONE MOUNT

(CRADLE)

(where provided)

F0S1328

There may be an armrest with

integrated storage compartment

between the front seats.

41)

There is a mount (A) fig. 83 on the

dashboard for your smartphone;

always use it in order to interact with

your smartphone safely.

F0S1135

To access the compartment, pull the

lever upwards (A) fig. 79 and lift the

armrest.

There is also a storage compartment

on the back (C) fig. 81.

CUP HOLDERS / CANS

AND HOLDERS

VOLUME AND "e-MODE"

ADJUSTMENT

CONTROLS

On the central tunnel there are two

cup/can holders, a retractable one on

the front part of the armrest ((A) fig. 80)

and one on the back ((B) fig. 81).

There are the following controls (fig. 82)

on the central console:

(A) - VOL: Turn the wheel up or down

charging phase, this will automatically

be interrupted.

not all closed correctly and the engine

is not on.

The wireless charging system is

enabled when the car is in running

condition and the vehicle battery is

sufficiently charged.

WARNING Do not place contactless

cards (RFID), credit cards or metal

objects in the charging compartment.

By interacting with the wireless charger

system and placing the mobile phone

in the specific housing, the user will

be informed by means from LED

(A) fig. 85indicating the state of the

wireless charging system:

WARNING To avoid damaging or

tearing the surface of the charging

compartment, do not place sharp

and/or pointed objects or objects other

than a mobile phone in it.

F0S1210

WIRELESS CHARGING

SYSTEM– WCPM

(Wireless Charge Pad

Module)

"Your phone is being charged" blue

LED: this is displayed when the mobile

phone is positioned correctly in the

wireless charging compartment and the

system is activated correctly;

"Phone fully charged" green LED: this

is displayed when the mobile phone

has completed charging its battery (if

suitable to transmit the information);

"Object not allowed" red LED: this

is displayed when a phone that is not

enabled for wireless charging or an

object that is not permitted (e.g. the

ignition key) is placed (e.g. ignition key,

credit card, a coin);

WARNING Not all mobile phone covers

guarantee the correct charging of

the phone. Check that charging is in

progress after having placed the phone

in the charging compartment.

(where provided)

The wireless charger system is

activated automatically when a mobile

phone Qi standard compatible is

placed in the storage compartment (A)

in fig. 84 on the central tunnel.

NOTE The use of multiple wireless

functions on the smartphone at the

same time (Apple CarPlay/Android

Auto and wireless charging), as

indicated by the smartphone

manufacturers, could cause it to

overheat, resulting in a limitation of the

active functions or its turning off. In this

case, it is recommended to connect

the system using the USB socket.

"System error" red LED: this appears

when there is a malfunction in the

wireless charger system;

"System not active" LED off: there

are no objects in the compartment

and/or the ignition device of the car in

the OFF position and/or the doors are

Correct positioning of the mobile

phone

F0S1138

To start charging wirelessly correctly,

make sure your mobile phone is

If the mobile phone is removed from

the housing during the wireless

KNOWING YOUR CAR -> INTERIOR FITTINGS for Your Fiat 500 SUV Second Generation (2020-2025)

Related Topics

KNOWING YOUR CAR

Popular Owner Manuals

Latest Owner Manuals