Get Doors and Locks -> Keyless Entry Guide for Ford Ecosport SUV 2020

Doors and Locks

Locking Using Intelligent Access

KEYLESS ENTRY (IF EQUIPPED)

General Information

Note: The system may not function if the

key is close to metal objects or electronic

devices such as cell phones.

The system will not function if:

Touch the outer door handle lock sensor

for approximately one second to lock,

being careful to not touch the unlock

sensor on the back of the door handle at

the same time. After locking, you can

immediately pull on the door handle to

confirm locking occurred without

inadvertently unlocking.

•

Your vehicle battery has no charge.

The passive key frequencies are

jammed.

•

The passive key battery is flat.

Note: If the system does not function, you

will need to use the key blade to lock and

unlock your vehicle.

The system allows you to operate your

vehicle without the use of a key or remote

control.

Note: Your vehicle does not lock itself

automatically. If you do not lock, your

vehicle will remain unlocked.

Note: Locking touch surfaces are located

on each of the front doors.

For central locking and to arm the alarm:

•

Touch the locking surface once.

After locking the doors with the lock

sensor, there is a brief delay before you can

unlock your vehicle.

This delay lets you pull the handle to make

sure your vehicle is locked.

Note: When the delay period is over, you

can open the doors again, provided the

Intelligent Access is within the respective

detection range.

Two short flashes of the direction

indicators confirms that all the doors and

swing gate have been locked and that the

alarm (if equipped) has been armed.

Locking and unlocking requires a valid

intelligent access key to be located within

one of the there external detection ranges.

These are located approximately 5 ft (1 m)

from the front door handles and from the

swing gate handle. You can also use the

Intelligent Access key as a remote control.

See Locking and Unlocking (page 60).

UnlockingUsingIntelligentAccess

EcoSport (CBW) Canada/United States of America, Vehicles Built From: 17-06-2019, LN1J-19A321-ZFA enUSA, Edition date: 201904, First-Printing

Doors and Locks

Note: Your vehicle remains locked for

Disabled Keys

longer than three days, the system will enter

an energy-saving mode. This is to reduce

the discharge of your vehicle battery. When

your vehicle is unlocked while in this mode,

the reaction time of the system may be a

little longer than normal. To exit the

Any keys left inside your vehicle interior

when it is locked will be disabled.

You cannot use a disabled key to switch

the ignition on or start the engine.

You must enable all Intelligent Access

energy-saving mode, unlock your vehicle.

again in order to use them.

With your intelligent access key within 5 ft

(1 m) of your vehicle, touch the unlock

sensor on the back of the door handle for

a brief period and then pull on the door

handle to unlock, being careful to not

touch the lock sensor at the same time or

pulling the door handle too quickly. The

intelligent access system requires a brief

delay to authenticate your intelligent

access key fob.

To enable all your Intelligent Access,

unlock your vehicle using a passive key or

the remote control unlocking function.

All Intelligent Access will then be enabled

if you switch the ignition on or your vehicle

is started using a valid key.

Intelligent Access - Locking and

Unlocking the Doors with the Key

Blade(If Equipped)

Note: Keep the door handle clean to make

sure the system operates correctly.

Note: A valid passive key must be located

within the detection range of that door.

One long flash of the direction indicators

confirms that all the doors and swing gate

have been unlocked and that the alarm (if

equipped) has been disarmed.

Unlocking only Driver Door

If the unlocking function is reprogrammed

so that only the driver door is unlocked See

Remote Control (page 51). Note the

following:

If the driver door is the first door which is

unlocked, the other doors and swing gate

will remain locked. All the other doors can

be unlocked from inside your vehicle by

pressing the unlock button located at the

front part of the front inner handles. Doors

can be unlocked individually by pulling the

interior door handles on those doors.

1. Push the release button and pull the

key blade out.

2. Remove the key blade and insert it into

If the front passenger door is the first door

which is unlocked, all the doors will be

unlocked.

the lock.

Note: Only the driver door handle has a lock

cylinder.

EcoSport (CBW) Canada/United States of America, Vehicles Built From: 17-06-2019, LN1J-19A321-ZFA enUSA, Edition date: 201904, First-Printing

Download User Manual App

Doors and Locks -> Keyless Entry for Your Ford Ecosport SUV 2020

Related Topics

Popular Owner Manuals

Latest Owner Manuals