2004-2009 Nissan Micra 4 Door Starting and driving -> Starting engine (model without Intelligent Key system) User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Starting and driving -> Starting engine (model without Intelligent Key system) for Your Nissan Micra 4 Door Third Generation (2004-2009)

ignition switch position will change to “ACC”.
NOTE:
. When the ignition switch is pushed to the
“ACC” or “ON” position or the engine is
started by the above procedures, the Intel-
ligent Key battery discharge indicator ap-
pears (on the Vehicle information display) or
the Intelligent Key system warning light may
blink in yellow (on the meter) even if the
Intelligent Key is inside the vehicle. This is
not a malfunction. To stop the warning light
from blinking, touch the ignition switch with
the Intelligent Key again.
. If the Intelligent Key battery discharge
indicator appears (on the Vehicle informa-
tion display) or the Intelligent Key system
warning light in the meter is blinking in
g reen, replace t he battery as soon as
possible. (See “Battery” (P.8-24).)
GUID-F3C623BE-87A8-45E1-84D8-1ACC85B1F10F
GASOLINE ENGINE
GUID-1FCDE0B8-5394-4508-841F-302493AACAA5
1. Apply the parking brake.
2. Depress the foot brake pedal.
3. Automatic Transmission (AT)/Continuously
Variable Transmission (CVT) model:
Move the shift lever to the “P” (Park) or “N”
(Neutral) position.
The starter is designed to operate only when
the shift lever is in the proper position.
Manual Transmission (MT) model:
Move the shift lever to the “N” (Neutral) position,
and depress the clutch pedal to the floor while
starting the engine.
The starter is designed to not operate unless
the clutch pedal is depressed.
4. Crank the engine with your foot off the accelerator
pedal by turning the ignition switch to the “START”
position.
5. Immediately release the ignition switch when the
engine starts. If the engine starts, but fails to run,
repeat the above procedures.
If the engine is very hard to start in extremely cold
or hot weather, depress the accelerator pedal and
hold it to help start the engine.
CAUTION:
. Do not operate the starter for more than 15
seconds at a time. If the engine does not
start, turn the ignition switch off and wait 10
seconds before cranking the engine again.
Otherwise, the starter could be damaged.
. If it becomes necessary to start the engine
with a booster battery and jumper cables,
the instructions and cautions contained in
the “6. In case of emergency” section should
be carefully followed.
6. Allow the engine to idle for at least 30 seconds
after starting the engine to warm-up. Drive at
moderate speeds for a shor t distance first,
especially in cold weather.
CAUTION:
Do not leave the vehicle unattended while the
engine is warming up.
DIESEL ENGINE
GUID-A6AEE369-FE83-4D6D-82D2-BF95CCACE180
1. Apply the parking brake.
2. Depress the foot brake pedal.
3. Move the shift lever to the “N” (Neutral) position,
and depress the clutch pedal to the floor while
starting the engine.
4. Turn the ignition switch to the “ON” position and
wait until the glow plug indicator light
turns
off.
5. Crank the engine with your foot off the accelerator
pedal by turning the ignition switch to the “START”
position.
6. Immediately release the ignition switch when the
engine starts. If the engine starts, but fails to run,
repeat the above procedures.
CAUTION:
. Do not operate the starter for more than 20
seconds at a time. If the engine does not
start, turn the ignition switch off and wait 20
seconds before cranking the engine again.
Otherwise, the starter could be damaged.
Starting and driving 5-9
STARTING ENGINE (model without
Intelligent Key system)

Related Topics

Popular Owner Manuals