[ Edit: 2014/ 11/ 7 Model: T32-A ]
OFF position
GUID-DA2B9201-206A-406B-891F-59A88D312FBD
The engine is turned off in this position.
Auto ACC position
GUID-0E2947FE-3378-4474-91C2-392C40908C39
With the vehicle in the “P” (Park) position, the
Intelligent Key with you and the ignition placed from
“ON” to “OFF”, the radio can still be used for a period
of time, or until the driver’s door is opened. After a
period of time, functions such as radio, navigation (if
equipped), and Bluetooth
®
Hands-Free Phone System
may be restarted by pressing the “POWER button/
VOLUME control knob” (See “Display screen, heater
and air conditioner, and audio system” (P.4-1) in this
manual) or the “UNLOCK” button on the Intelligent Key
up to a total of 30 minutes.
INTELLIGENT KEY BATTERY DISCHARGE
GUID-DDD49134-EED6-4344-B5AB-8DE3B2930F7E
JVS0404X
If the battery of the Intelligent Key is discharged, or
environmental conditions interfere with the Intelligent
Key operation, start the engine a ccording to the
following procedure:
1. Continuously Variable Transmission (CVT)
model:
Move the shift lever to the “P” (Park) or “N”
(Neutral) position.
Manual Transmission (MT) model:
Move the shift lever to the “N” (Neutral) position.
2. Firmly depress the brake pedal.
3. Touch the ignition switch with the Intelligent Key
as illustrated. (A chime will sound.)
4. Push the ignition switch while depressing the
brake pedal (CVT model) or the clutch pedal (MT
model) within 10 seconds after the chime sounds.
The engine will start.
After step 3 is performed, when the ignition switch is
pushed without depressing the brake pedal (CVT
model) or the clutch pedal (MT model), the ignition
switch position will change to “ON”.
NOTE:
. When the ignition switch is placed in the
“ON” position or the engine is started by the
above procedures, the “Key battery low”
warning appears (on the Vehicle information
display) even if the Intelligent Key is inside
the vehicle. This is not a malfunction. To turn
off the warning, touch the ignition switch
with the Intelligent Key again.
. If the “Key battery low” warning appears (on
the Vehicle information display), replace the
battery as soon as possible. (See “Battery”
(P.8-20).)
GUID-4E257898-08E9-4BFE-8FAD-8C094EFB2296
1. Apply the parking brake.
2. Depress the foot brake pedal.
3. Move the shift lever to the “N” (Neutral) position,
and depress the clutch pedal to the floor while
starting the engine.
The starter is designed to not operate unless
the clutch pedal is depressed.
4. Crank the engine with your foot off the accelerator
pedal by turning the ignition switch in the “START”
position.
For diesel engine models: Wait until the glow
indicator light
goes out.
5. Immediately release the ignition switch when the
engine starts. If the engine starts, but fails to run,
repeat the above procedures.
If the engine is very hard to start in extremely cold
or hot weather, depress the accelerator pedal and
hold it to help start the engine.
CAUTION:
. Do not operate the starter for more than 15
seconds at a time. If the engine does not
start, place the ignition switch off and wait
10 seconds before cranking the engine
again. Otherwise, the starter could be da-
maged.
. If it becomes necessary to start the engine
with a booster battery and jumper cables,
the instructions and cautions contained in
the “6. In case of emergency” section should
be carefully followed.
6. Allow the engine to idle for at least 30 seconds
after starting the engine to warm-up. Drive at
moderate speeds for a short distance first,
Starting and driving 5-11
STARTING ENGINE (model without
Intelligent Key system)
Condition: 'Except for China'/
English 
