[ Edit: 2014/ 11/ 7 Model: T32-A ]
. when the engine coolant temperature is low.
. when the battery capacity is low.
. when the battery temperature is low.
. when the vehicle is moved.
. when the vacuum in the brake servo de-
creases.
. when the engine hood is opened with the
engine running.
. whe n the engine is turned on with the
engine hood open.
. when the driver’s seat belt is not fastened.
. when the driver’s door is open.
. when the steering wheel is operated (for
CVT model).
. when the Stop/Start or Idling Stop System
indicator blinks at a low speed.
. when the fan speed control is in any position
other than “OFF” (0) while the air flow
control is in the front defogger position.
. when the front defogger switch is on.
. when the temperature inside the vehicle is
too high or low. (When the air conditioner is
off, the Stop/Start System or Idling Stop
System will operate.)
. when the fan speed of the air conditioner is
set to the maximum speed.
. when the Stop/Start or Idling Stop OFF
switch is turned on.
. when the power consumption is large.
. when the vehicle is traveling at altitudes
higher than 2,000 m (6,562 ft) (for MT model).
. when the vehicle is travelling at altitudes
higher than 1500m (4922 ft) (R9M engine in
combination with CVT models).
. For Manual Transmission (MT) models
— when the shift lever is in any position
except the “N” (Neutral) position.
— when the clutch pedal is depressed.
— when the Intelligent Key is not in the
vehicle.
. For Con tinuously Variable Transmission
(CVT) models
— when the accelerator pedal is depressed.
— when the shift lever is in the “R” (Reverse)
position.
— when the brake pedal is not firmly
depressed.
— when stopping the vehicle on steep
sloping roads.
. when the electric power steering warning
light, the Anti-lock Braking System (ABS)
warning light, or the Vehicle Dynamic Con-
trol (VDC)/Electronic Stability Program
(ESP) warning light illuminates.
NOTE:
The engine will not restart even if the brake
pedal is released (CVT) or clutch pedal is
pressed (MT) while the Stop/Start System or
Idlin g Stop System is activated under the
following condition:
. when the shift lever is in the “P” (Park)
position (CVT model).
. when the engine hood is opened.
. when the driver seat belt is unfastened and
the driver’s door is opened (MT model).
. when the gear shift lever is not in the Neutral
position (MT models).
NOTE:
It may take some time until the Stop/Start or
Idling Stop System activates under the following
conditions:
. when the battery is discharged.
. when the outside temperature is low or high.
. when the battery is replaced or the battery
terminal is disconnected for extended peri-
ods and then reconnected.
NOTE:
When the St op/Start System or Idling Stop
indicator illuminates, the engine starts running
automatically under at least one of the following
conditions:
. the brake pedal is released with the shift
lever in the “D” (Drive) or “N” (Neutral)
position (for CVT model).
. the shift lever is placed in the “D” (Drive) or
“R” (Reverse) position from the “N” (Neutral)
or “P” (Park) position (for CVT model).
. the driver’s seat belt is unfastened, or the
driver’s door is open (for CVT model).
. the battery voltage becomes low (due to
electrical load from other vehicle systems
like headlights, heaters, etc., or auxiliary
devices c onnected to the 12 volt socket
inside the vehicle).
. the vehicle speed is above about 2 km/h (1
MPH).
. the front defogger is operated.
. when the temperature inside the vehicle is
too high or low. (When the air conditioner is
off, the Stop/Start System or Idling Stop
System will operate.)
Starting and driving 5-19
Condition: 'Except for China'/
English 
