Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤ , Jetta 2011 ➤
6-Speed Manual Transmission 02Q - Edition 05.2013
2
Flange Shaft Seals and Bevel Box,
Replacing for AWD Vehicles (Manual
Transmission already Installed)
⇒ “2.1 Left Flange Shaft Seal, Replacing”, page 373
⇒ “2.2 Right Flange Shaft Seal, Replacing”, page 373
⇒ “2.3 Bevel Box Seal, Replacing, with Manual Transmission In‐
stalled”, page 375
2.1
Left Flange Shaft Seal, Replacing
Replacing the seal on the left flange shaft on AWD and FWD ve‐
hicles is identical. Refer to
⇒ “1.1 Left Flange Shaft Seal, Replacing”, page 369 .
2.2
Right Flange Shaft Seal, Replacing
Special tools and workshop equipment required
♦ Puller - Flanged Shaft - T10037-
♦ Seal Installer - Flange Shaft - T10049-
♦ Socket And Extended Bit - T10107-
♦ or Socket And Extended Bit - T10107A-
♦ Torque Wrench 1331 5-50Nm - VAG1331-
♦ Sealing Grease - G 052 128 A1-
♦ Shop Crane - Drip Tray - VAS6208-
Removing
The right drive axle must be removed later in the procedure.
– With the vehicle still standing on its wheels, loosen the right
front collar bolt -arrow- a maximum 90°, otherwise the wheel
bearing will get damaged. Refer to ⇒ Suspension, Wheels,
Steering; Rep. Gr. 40 ; Drive Axles, Removing and Installing .
– Remove the right front wheel.
– Remove the noise insulation under the engine/transmission, if
equipped. Refer to ⇒ Body Exterior; Rep. Gr. 50 ; Noise In‐
sulation .
– Remove the drive axle heat shield from the bevel box
-arrows-.
– Remove the right drive axle. Refer to ⇒ Suspension, Wheels,
Steering; Rep. Gr. 40 ; Drive Axles, Removing and Installing .
2. Flange Shaft Seals and Bevel Box, Replacing for AWD Vehicles (Manual Transmission already Installed)
373
English 
