Advertisement

Advertisement

Descriptions of work -> Window wash/wipe system and headlight washer system: checking function for Your Volkswagen Taigo SUV First Generation (2021-2025)

Polo 2018 ➤, Polo 2022 ➤, Taigo 2022 ➤  
Maintenance - Edition 10.2021  
♦ From a remaining distance of 0 km, a warning buzzer  
sounds three times and “Check AdBlue (DEF)!” is dis‐  
played“ Engine start no longer possible”.  
Note  
As soon as the message “Check AdBlue! No engine start pos‐  
sible! ” is displayed and the engine is switched off; the engine  
cannot be started again.  
– Fault recovery ⇒ Guided fault finding  
4.42.2  
Health risk and cleaning  
CAUTION  
®
AdBlue /DEF is an irritant and corrosive fluid!  
Risk of irritation and injury to skin, eyes and respiratory or‐  
gans.  
®
In the event of AdBlue /DEF coming into contact with the  
eyes, wash off immediately with water for at least 15 mi‐  
nutes, and seek medical assistance.  
®
In the event of skin contact with AdBlue /DEF, wash off  
immediately with water.  
®
In the event of AdBlue /DEF ingestion, rinse out the  
mouth immediately with water for at least 15 minutes. Do  
not induce vomiting unless instructed to do so by a doctor.  
Seek medical assistance without delay.  
NOTICE  
®
AdBlue /DEF is an irritant and corrosive fluid. When left ex‐  
posed to air, reducing agent residue will crystallise after some  
time.  
Risk of damage to trims and body parts.  
®
Wash off reducing agent (AdBlue /DEF) with clear water  
and a lint-free cotton cloth.  
®
If the reducing agent (AdBlue /DEF) has already crystal‐  
lised, use warm water and a sponge.  
4.42.3  
Disposal instructions  
Note  
Information reference storage and disposal ⇒ Infonet, Oper‐  
ation, Strategy and deadlines, Environment, Handbook Serv‐  
ice Environmental Protection! Ask your importer about coun‐  
try-specific information on storage and disposal.  
The refill container must be disposed of in accordance with  
environmental regulations.  
136  
4. Descriptions of work  
Polo 2018 ➤, Polo 2022 ➤, Taigo 2022 ➤  
Maintenance - Edition 10.2021  
4.42.4  
Reducing agent tank: filling  
Procedure  
Note  
Ensure that the vehicle is on a hard, level standing and that  
the ignition is switched off.  
Refer to the ⇒ Operating manual for the filling device for  
AdBlue -VAS 6960-.  
Use only demineralised water for cleaning any components  
®
of the AdBlue /DEF system. Do not use tap water for this.  
– Switch off ignition.  
®
The filler opening for the reduction agent tank (AdBlue /DEF) is  
located under the tank flap.  
– Open fuel tank flap.  
– Open the tank cap -arrow- of the reducing agent tank (AdBl‐  
®
ue /DEF) under the fuel tank flap.  
– Clean reducing agent tank filler neck with a water-soaked,  
lint-free cotton cloth.  
– Insert filler nozzle of filling device for AdBlue -VAS 6960- into  
filler neck of tank for reducing agent, and start filling the tank  
for reducing agent.  
Note  
The filler nozzle of the filling device for AdBlue -VAS 6960-  
stops automatically when the required reducing agent level has  
been attained.  
– Remove filler nozzle.  
– Screw on tank cap -arrow- of the reducing agent tank (AdBl‐  
®
ue /DEF) until the cap locks.  
4. Descriptions of work  
137  
Polo 2018 ➤, Polo 2022 ➤, Taigo 2022 ➤  
Maintenance - Edition 10.2021  
– Close tank flap.  
Note  
After filling the reducing agent tank, switch on the ignition and  
leave it switched on for at least 30 seconds so that the system  
can detect the replenishment.  
Reducing agent (AdBlue®/DEF):  
changing  
4.43  
Procedure  
– ⇒ Rep. gr. 26; SCR system (selective catalytic reduction)  
4.44  
Tyre Pressure Loss Indicator: calibrat‐  
ing  
Note  
The calibration of the Tyre Pressure Loss Indicator must on‐  
ly be performed “after” the tyre pressure has been corrected  
to the prescribed values.  
If no pressure loss and tyre damage are found after a tyre  
pressure warning, the incorrect warning can be rectified by  
calibrating.  
Tyre Pressure Loss Indicator compares the speed and thus  
the rolling circumference and vibrations of the individual wheels  
via the ABS sensors. If the tyre pressure changes on one or  
several wheels, the Tyre Pressure Loss Indicator will indicate  
this in the dash panel insert and the Infotainment system.  
The rolling circumference of tyre changes if:  
♦ The tyre pressure is too low.  
♦ The tyre has structural damage.  
♦ The vehicle is loaded more heavily on one side.  
♦ The wheels on one axle are loaded more heavily (e.g. when  
towing a trailer or when driving in mountains).  
♦ Snow chains are fitted.  
♦ The temporary spare wheel is fitted.  
♦ One wheel per axle has been changed.  
138  
4. Descriptions of work  
Polo 2018 ➤, Polo 2022 ➤, Taigo 2022 ➤  
Maintenance - Edition 10.2021  
The Tyre Pressure Loss Indicator warning lamp has a yellow  
warning lamp in the dash panel insert.  
♦ A “PERMANENT LIGHTING-UP” in conjunction with a warn‐  
ing tone, means “WARNING”, pressure loss has been detec‐  
ted, check tyre pressure and carry out calibration.  
Calibration, version 1  
– Switch on ignition.  
– Switch on Infotainment system.  
– Press CAR function button.  
– Press Setup function button.  
– Press Tyres function button.  
– Press Set function button.  
– Press Confirm function button.  
Calibration, version 2  
– Switch on ignition.  
– Press and hold button -arrow- in centre console for longer  
than 2 seconds.  
An audible signal confirms that basic setting has been per‐  
formed.  
4.45  
Tyre repair set: checking  
Note  
Depending on the equipment level, the vehicles are equip‐  
ped with a breakdown set.  
It also contains a filling bottle with tyre sealant.  
4. Descriptions of work  
139  
Polo 2018 ➤, Polo 2022 ➤, Taigo 2022 ➤  
Maintenance - Edition 10.2021  
Version 1  
Version 2  
The breakdown set is located under the luggage compartment  
floor.  
The breakdown set includes a bottle of tyre sealant -2- and a  
compressor -1-.  
The tyre sealant in the bottle has a limited storage life.  
The expiry date is therefore specified on the bottle -2-.  
– Enter expiry date in maintenance table.  
– If the expiry date has been reached, replace tyre sealant.  
(The tyre sealant must not be more than 4 years old).  
4.46  
Window wash/wipe system and head‐  
light washer system: checking function  
Checking anti-freeze protection of fluid, topping up fluid ⇒ page  
140  
Window wash/wipe system: check spray jet settings and adjust  
if necessary ⇒ page 142  
Headlight washer system: checking spray jet settings ⇒ page  
143  
Windscreen wiper blades: check park position ⇒ page 144 .  
Rear window wiper blades: checking park position ⇒ page 144  
4.46.1  
Anti-freeze: checking protection of flu‐  
id, topping up fluid if necessary  
Special tools and workshop equipment required  
♦ Refractometer -T10007A-  
140  
4. Descriptions of work  

Related Topics