2019-2026 Lexus UX SUV Using the driving support systems -> Emergency Driving Stop System User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Using the driving support systems -> Emergency Driving Stop System for Your Lexus UX SUV First Generation (2019-2026)

262
4-5. Using the driving support systems
Operation of this system is separated
into 4 control states. Through control
state “warning phase 1” and “warning
phase 2”, the system determines if the
driver is aware and responsive while
outputting a warning and controlling
the vehicle speed. If the system deter-
mines the driver is not responsive, it will
operate in control state “deceleration
Emergency Driving Stop
S
ystem
The emergency driving stop system
is a system which automatically
decelerates and stops the vehicle
within its lane if the driver becomes
unable to continue driving the vehi-
cle, such as if they have suffered a
medical emergency, etc.
During LTA (Lane Tracing Assist)
control, if the system does not
detect driving operations, such as if
the driver is not holding the steer-
ing wheel, and determines the
driver is not responsive, the vehicle
will be decelerated and stopped
within its current lane to help avoid
a collision or reduce the impact of a
collision.
WARNING
■ For safe use
● Driving safely is solely the responsibil-
ity of the driver. Pay careful attention
to the surrounding conditions in order
to ensure safe driving. The emergency
driving stop system is designed to pro-
vide support in an emergency where it
is difficult for the driver to continue
driving, such as if they have had a med-
ical emergency. It is not designed to
support driving while drowsy or in
poor physical health, or inattentive
driving.
● Although the emergency driving stop
system is designed to decelerate the
vehicle within its lane to help avoid or
help reduce the impact of a collision if
the system determines that it is difficult
for the driver to continue driving, its
effectiveness may change according
to various conditions. Therefore, it may
not always be able to achieve the same
level of performance. Also, if the oper-
ating conditions are not met, this func-
tion will not operate.
● After the emergency driving stop sys-
tem operates, if driving becomes pos-
sible again, immediately begin driving
again or, if necessary, park the vehicle
on the shoulder of the road and set a
warning reflector and flare to warn
other drivers of your stopped vehicle.
● After this system operates, passengers
should attend to the driver as neces-
sary and take appropriate hazard pre-
vention measures, such as moving to a
place where safety can be ensured,
such as the shoulder of the road or
behind a guardrail.
● This system detects the condition of
the driver through the operation of the
steering wheel. This system may oper-
ate if the driver is aware but intention-
ally and continuously does not operate
the vehicle. Also, the system may not
operate if it cannot determine that the
driver is not responsive, such as if they
are leaning on the steering wheel.
Summary of the system
263
4-5. Using the driving support systems
4
Driving
stop phase” and “stop hold phase” and
decelerate and stop the vehicle. It will
then operate continuously in “stop hold
phase”.
■ Operating conditions
This system operates when all of the follow-
ing conditions are met:
● When the LTA is on
● When the vehicle speed is approximately
30 mph (50 km/h) or more
■ Operation cancelation conditions
In the following situations, system operation
will be canceled:
● When LTA control has been canceled
(the LTA switch has been pressed, etc.)
● When the dynamic radar cruise control
has been canceled
● When driver operations are detected
(the steering wheel is held, the brake
pedal, accelerator pedal, parking brake,
emergency flasher switch, or turn signal
lever is operated)
● When the driving assist switch is pressed
while in the stop and hold phase
● When the power switch has been turned
from ON to off
● Situations in which some or all of the
functions of the system cannot operate:
P.220
■ LTA control when operation is canceled
When emergency driving stop system
operation is canceled, LTA control may
also be canceled.
If driving operations are not detected
after the hands off steering wheel
warning operates, a buzzer will sound
intermittently and a message will be
displayed to warn the driver, and the
system will judge if the driver is respon-
sive or not. If driving operations, such
as holding the steering wheel, are not
performed within a certain amount of
time, the system will enter warning
phase 2.
After entering warning phase 2, a
buzzer will sound in short intervals and
a message will be displayed to warn
the driver, and the vehicle will slowly
decelerate. If driving operations, such
as holding the steering wheel, are not
performed within a certain amount of
time, the system will determine that the
driver is not responsive and enter the
deceleration stop phase.
The audio system will be muted until the
driver becomes responsive.
When the vehicle is decelerating, the
brake lights may illuminate, depending on
the road conditions, etc.
After entering the deceleration stop
phase, a buzzer will sound continu-
ously and a message will be displayed
to warn the driver, and the vehicle will
slowly decelerate and stop. After the
vehicle stops, the system will enter the
stop and hold phase.
After the vehicle is stopped, the park-
ing brake will be applied automatically.
After entering the stop and hold phase,
the buzzer will continue sounding con-
tinuously and the emergency flashers
Warning phase 1
Warning phase 2
Deceleration stop phase
Stop hold phase
264
4-5. Using the driving support systems
(hazard lights) will flash to warn other
drivers of the emergency.
■ Restricted functions after the
operation is canceled
After shifting to the deceleration stop
phase, the following functions will not
be available until the hybrid system is
restarted even though the emergency
driving stop system is canceled:
LTA
Center Display
BSM (Blind Spot Monitor)
The Blind Spot Monitor is a system
that uses rear side radar sensors
installed on the inner side of the
rear bumper on the left and right
side to assist the driver in confirm-
ing safety when changing lanes.
WARNING
■ Cautions regarding the use of the
system
● The driver is solely responsible for safe
driving. Always drive safely, taking
care to observe your surroundings.
● The Blind Spot Monitor is a supple-
mentary function which alerts the
driver that a vehicle is in a blind spot of
the outside rear view mirrors or is
approaching rapidly from behind into
a blind spot. Do not overly rely on the
Blind Spot Monitor. As the function
cannot judge if it is safe to change
lanes, over reliance could lead to an
accident resulting in death or serious
injury.
As the system may not function correctly
under certain conditions, the driver’s
own visual confirmation of safety is nec-
essary.
System components
A

Related Topics

Popular Owner Manuals