2006-2014 Nissan Qashqai SUV Pre-driving checks and adjustments -> Integrated keyfob/remote control system User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Pre-driving checks and adjustments -> Integrated keyfob/remote control system for Your Nissan Qashqai SUV First Generation (2006-2014)

INTEGRATED KEYFOB/REMOTE  
CONTROL SYSTEM  
KEY NUMBER  
EMERGENCY/MECHANICAL KEY  
(Intelligent Key models)  
A key number plate j3 is supplied with your key  
Record the key number on the “Security Informa-  
tion” page at the end of this manual and keep it in a  
safe place, but not in the vehicle. The key can only  
be duplicated using an original key or the original  
key number. The key number is required when you  
have lost all of the keys and do not have the original  
key to duplicate from. If the key is lost, or you need  
extra keys, provide an original key or the key number  
to a NISSAN dealer or qualified workshop.  
NPA1082  
Integrated keyfob  
NPA1050  
NISSAN does not record key numbers, so it is very  
important that you keep a record of your key num-  
ber.  
The emergency key can be used to unlock the driv-  
er’s door and start the engine in emergency situa-  
tions (e.g. Intelligent Key dead battery).  
NEW KEYS  
As many as four NATS keys can be registered to  
one vehicle at any one time. New keys must be reg-  
istered to the NATS components of your vehicle by  
a NISSAN dealer.  
To use the mechanical key, release the lock knob  
located on the side of the Intelligent Key then slide  
and remove the cap. Unfold the mechanical key from  
its housing until it locks in place.  
NPA1083  
When registering a new key at a NISSAN dealer,  
you are requested to bring all of your NATS keys  
with you. This is necessary because the registration  
process will erase and reprogram the memory of  
your vehicle’s NATS components.  
Use the mechanical key to lock or unlock the doors.  
(See “Door locks” later in this section.)  
Intelligent key  
The remote keyless entry system can operate all  
door locks (including the back door) using the inte-  
grated keyfob. The integrated keyfob can operate at  
a distance of approximately 5 m (15 ft) from the  
vehicle (the effective distance depends upon the  
conditions around the vehicle and the state of the  
keyfob battery).  
For further details on accessing and using the emer-  
gency key, see “Ignition knob (where fitted)” in the  
“5. Starting and driving” section.  
NOTE  
NOTE  
A key number is only required if you have lost all  
of your keys and do not have one to duplicate  
from. If you still have a key, this key can be dupli-  
cated by a NISSAN dealer.  
For the driver side door, it is normal for the key  
not to go all the way into the key cylinder.  
As many as 5 remote controllers can be used with  
one vehicle. For information about the purchase and  
Pre-driving checks and adjustments 3-3  
Downloaded from manuals search engine  
use of additional remote controllers, contact a  
NISSAN dealer or qualified workshop.  
Always remove the ignition key or Intelligent  
Key, close all windows before operating the  
keyfob door lock system.  
•
•
SWITCHING FROM CONVENIENCE  
MODE TO ANTI-HIJACK MODE  
The integrated keyfob will not function under the fol-  
lowing conditions:  
Selective unlock or “Anti-hijack” mode allows the  
remote unlocking of only the driver’s door to prevent  
an attacker from entering the vehicle via an unlocked  
passenger door.  
Ensure that the driver’s door is securely  
closed before operating the integrated keyfob  
door lock system for correct operation of the  
system.  
When the distance between the integrated key-  
fob and vehicle is more than approximately 5 m  
(15 ft).  
•
As default, the unlock mode will be set to “Conve-  
nience” mode (all doors will unlock). Follow the in-  
structions below to switch between convenience  
mode and anti-hijack mode.  
Do not allow the integrated keyfob, which  
contains electrical components, to come into  
contact with water or salt water. This could  
affect the system function.  
•
When the integrated keyfob battery is  
discharged.  
•
When the key is in the ignition switch.  
•
jA Key with integrated keyfob (from  
outside the vehicle)  
All doors can be locked or unlocked from the out-  
Do not drop the integrated keyfob.  
•
•
side by pressing the “LOCK”  
button on the integrated keyfob.  
or “UNLOCK”  
Do not strike the integrated keyfob sharply  
against another object.  
1. Turn the ignition switch to the “OFF” position.  
For Super Lock system models only (RHD mod-  
els):  
2. Press and hold both the “LOCK”  
LOCK” buttons for 5 seconds.  
and “UN-  
Do not place the integrated keyfob for an ex-  
tended period in an area where temperatures  
exceed 60°C (140°F).  
•
When the vehicle is occupied, never lock the  
doors with the integrated keyfob. Doing so will  
trap the occupants, since the Super Lock system  
prevents the doors from being opened from the  
inside.  
Setting anti-hijack mode:  
The direction indicators flash once.  
Setting convenience mode:  
The direction indicators flash three times.  
–
If a integrated keyfob is lost or stolen, NISSAN rec-  
ommends erasing the ID code of that integrated  
keyfob from the vehicle. This may prevent the unau-  
thorised use of the integrated keyfob to unlock the  
vehicle. For information regarding the erasing pro-  
cedure, contact a NISSAN dealer or qualified work-  
shop.  
–
jB Intelligent Key  
WARNING  
1. Turn the ignition switch from ON to LOCK and  
exit the vehicle.  
Only operate the integrated keyfob lock button in  
full and clear view of the vehicle to prevent any-  
body being trapped inside the vehicle.  
For information regarding the replacement of a bat-  
tery, see “Battery” in the “8. Maintenance and  
do-it-yourself” section.  
2. From outside the vehicle, lock the vehicle using  
the integrated keyfob “LOCK” button  
.
CAUTION  
3. Press and hold both the “LOCK”  
and “UN-  
When locking the doors using the integrated  
keyfob, be sure not to leave the key in the  
vehicle.  
•
LOCK”  
buttons for 10 seconds.  
4. Within 3 seconds, press and hold the driver’s  
3-4 Pre-driving checks and adjustments  
Downloaded from manuals search engine  
door outside lock switch until the direction indi-  
cators flash to confirm the setting mode. Then  
release the driver’s door outside lock switch.  
Setting convenience mode:  
LOCKING THE DOORS  
–
The message [All door unlock] appears on  
the vehicle information display (inside the ve-  
hicle).  
CAUTION  
Before operating the keyfob remote control:  
Remove the ignition key or Intelligent Key  
from the vehicle and close all windows.  
•
See “Warning/indicator lights and audible  
reminders” in the “2. Instruments and controls” sec-  
tion and “Vehicle information display” in the “2. In-  
struments and controls” section for further details.  
Check that the driver’s door is securely  
closed.  
•
Push the “LOCK” button  
fob.  
on the integrated key-  
USING THE REMOTE KEYLESS  
ENTRY SYSTEM  
–
–
All the doors lock.  
The direction indicators flash once.  
is pushed with all the doors  
NPA1041  
WARNING  
Super Lock system equipped models:  
If the “LOCK” button  
5. Setting anti-hijack mode:  
Failure to follow the precautions below may lead  
to hazardous situations. Make sure the Super  
Lock system activation is always conducted  
safely.  
locked, the direction indicators will flash once to  
remind you that the doors are already locked.  
–
The message [Single door unlock] appears  
on the vehicle information display (inside the  
vehicle).  
UNLOCKING THE DOORS  
Convenience mode  
When the vehicle is occupied, never lock the  
•
doors with the integrated keyfob. Doing so  
will trap the occupants, since the Super Lock  
system prevents the doors from being opened  
from the inside of the vehicle.  
Push the “UNLOCK” button  
keyfob.  
on the integrated  
–
The message [All door unlock] appears in the  
vehicle information display.  
Only operate the integrated keyfob “LOCK”  
•
–
–
All doors unlock.  
button when there is a clear view of the ve-  
hicle. This is to prevent anybody from being  
trapped inside the vehicle through the Super  
Lock system activation.  
The direction indicators flash twice.  
NPA1040  
Anti-hijack mode  
1. Push the “UNLOCK” button  
keyfob.  
on the integrated  
For further details on the Super Lock system see  
“Super Lock system (RHD models)” later in this  
section.  
Pre-driving checks and adjustments 3-5  
Downloaded from manuals search engine  
INTELLIGENT KEY SYSTEM  
(where fitted)  
–
The message [Single door unlock] appears in  
the vehicle information display.  
–
–
Only the driver’s door unlocks.  
The direction indicators flash twice, quickly.  
2. Push the “UNLOCK” button  
keyfob again.  
on the integrated  
–
–
All doors unlock.  
The direction indicators flash twice.  
NPA1042  
NPA1018  
Auto-relock:  
NOTE  
The Intelligent Key system is a convenient keyless  
entry system that allows you to operate your vehicle  
without using an actual key.  
An auto-relock function will operate 2 minutes after  
a full or partial unlock, if no further user action is  
taken. The auto-relock will be cancelled if any door  
is opened or the key is inserted into the ignition.  
See Intelligent Key detection warning, Intelligent  
Key low battery warning or Intelligent Key system  
fault warning in “Vehicle information display” ear-  
lier in this section for more information.  
WARNING  
KEYFOB OPERATION FAILURE  
Radio waves could adversely affect electric medi-  
cal equipment. Those who use a pacemaker  
should contact the electric medical equipment  
manufacturer for the possible influences before  
use.  
The keyfob may not work properly if:  
The keyfob battery is low. See “Integrated key-  
•
fob/Intelligent Key battery replacement” in the  
“8. Maintenance and do-it-yourself” section for  
keyfob battery replacement instructions and the  
required battery type.  
INTELLIGENT KEY OPERATING  
RANGE  
The locking/unlocking system has been used  
•
The Intelligent Key functions can only be used when  
the Intelligent Key is within the specified operating  
range from the request switch j1 .  
continuously. An anti lock-abuse system pre-  
vents the lock motors from overheating and dis-  
ables the keyfob locking operation for a short  
period of time if the system is used continuously.  
When the Intelligent Key battery is discharged or  
strong radio waves are present near the operating  
location, the Intelligent Key system’s operating  
range becomes narrower, and the Intelligent Key  
may not function properly.  
The door handle is being pulled while the  
keyfob is being operated.  
•
The vehicle’s battery is dead.  
•
3-6 Pre-driving checks and adjustments  
Downloaded from manuals search engine  

Related Topics

Popular Owner Manuals