78 Seats and Stowage
If you wish to be able to retrieve the settings which are stored in the memory by also
using the radio remote control, you have to assign the radio remote control to a
memory button in each case.
–
–
–
Engage the reverse gear.
Move the right exterior mirror into the desired position ⇒ page 73.
Take the vehicle out of gear. The set position of the exterior mirror is
stored.
If you wish, you can obtain an additional remote control key from an authorised
Škoda Service partner and then assign the remote control key to another memory
button.
Memory buttons
Memory for the seat offers the possibility to store the individual driver seat and
external mirror position. An individual position can be allocated to each of the three
Note
•
If the radio remote control had previously been assigned to another memory
button, this setting is then erased by the new assignment.
If you assign the radio remote control to a memory button which has already
been assigned to a radio remote control, the old assignment is also replaced by a
new assignment in this case.
B
memory buttons A ⇒ page 77, fig. 76, that is three in total. After pressing the
B
corresponding memory button A, the seat and the exterior mirror are automati-
cally moved into the positions which have been allocated to this button ⇒ page 78.
•
Emergency Off
You can interrupt the setting operation at any time, if you operate any button of the
driver seat.
•
The assignment of the radio remote control to a memory button is retained,
however, after reassigning the seats and exterior mirrors.
Note
Retrieving settings of the seat and mirrors
•
When storing settings with the memory buttons, we recommend that you begin
You can retrieve the stored settings either with the memory buttons
or with the remote control*.
with the front button and assign a memory button to each additional driver.
•
•
Each new setting stored with the same button erases the previous setting.
Each time you store the seat and exterior mirror settings for driving forward you
Retrieving settings with memory buttons
also have to re-store the individual setting of the exterior mirror on the passenger
side for reversing.
–
–
In order to retrieve the stored setting, you have two possibilities:
One-touch automatic memory: Briefly press the desired memory
B
button A⇒ page 77, fig. 76. The seat and exterior mirror are moved
Assigning remote control to the memory buttons
automatically into the stored positions (this applies only if the ignition
is switched on and the speed is less than 5 km/h).
After storing the settings of the seat and exterior mirrors, you have 10
seconds in order to assign the radio remote control to the appropriate
memory button.
B
–
Memory keying: Press and hold the desired memory button A
pressed long enough until the seat and the exterior mirror are moved
into the stored positions.
–
–
Withdraw the ignition key.
Press the unlock button ⇒ page 50. The setting is stored with the
memory button which you have selected.
English 
