Seats and Stowage 93
Installing
WARNING
–
–
–
Position the net partition housing into the mounts of the rear seat
backrests.
•
The belt locks and the belts must be in their original position after folding
back the seat cushions and the seat backrests - they must be ready to use.
1
Push the net partition housing in the opposite direction of arrow A
as far as the stop.
•
The seat backrests must be securely interlocked in position so that no
objects in the luggage compartment can slide forward if there is sudden
braking - risk of injury!
Fold the rear seats back into its original position.
•
Pay attention that the rear seat backrest is correctly interlocked. It is only
then that the three-point seat belt for the middle seat can reliably fulfil its
function.
The roof rack*
C
•
First check for yourself that the cross road is inserted into the mounts A
in the front position!
Description
Pay attention to the following points if you wish to transport luggage or other items
on the roof of your vehicle:
Removing and installing net partition housing
•
A special roof luggage rack system was developed for the vehicle, that is why
you should only use a roof luggage rack which has been released for use by Škoda
Auto.
•
The base carrier is the basis for a complete roof luggage rack system. Separate
additional holders are required for safety reasons for transporting luggage, bikes,
surfboards, skis and boats.
•
The basic version of the roof luggage rack system and further components are
obtainable as accessories from the authorised Škoda Service Partners.
Fig. 107 Rear seats: Net
partition housing
Caution
•
If you use other roof rack systems or if the roof bars are not properly fitted, then
any damage which may result to your car is not covered by the warranty agree-
ments. It is therefore essential to pay attention to the fitting instructions supplied
with the roof luggage rack system.
Removing
–
–
–
Fold the rear seats forwards ⇒ page 81
Open the right rear door.
• On models fitted with a power sliding/tilting roof, ensure that the opened
sliding/tilting roof does not strike any items of luggage transported on the roof.
Ensure that the opened boot lid does not collide with the roof load.
A
Push the net partition housing A⇒ fig. 107 in the direction of arrow
•
1
A and take it out of the mounts of the rear seats in the direction of
2
arrow A.
Using the system
Safety
Driving Tips
General Maintenance
Breakdown assistance
Technical Data
English 
