50 Unlocking and locking
Unlocking and locking car
1
button A but do not open a door or the boot lid within the next 30 seconds. This
function is intended to prevent the car being unlocked unintentionally.
In addition, when the car is unlocked, the electrically adjustable seats and exterior
mirrors* move into the position assigned to this key. The stored setting of driver
seat and exterior mirrors is retrieved.
Display of the locking
The turn signal lights flash once to confirm that the vehicle has been correctly
locked.
3
If the vehicle is locked by pressing the button Aand some doors or the boot lid are
not closed, the turn signal lights flash only after closing.
Fig. 47 Remote control key
WARNING
Unlocking the vehicle
If the vehicle is locked from the outside and the safe securing system is acti-
vated, there must not be any person in the vehicle as it is then not possible
to open either a door or a window from the inside. The locked doors make it
more difficult for rescuers to get into the vehicle in an emergency - hazard!
1
–
Press the button A ⇒ fig. 47 for about 1 second.
Locking the vehicle
3
–
Press button A for about 1 second.
Note
Deactivating safe securing system
•
Operate the radio remote control only when the doors and boot lid are closed
and you have visual contact with the vehicle.
Once in the car, you must not press the lock button of the radio remote
control before inserting the key into the ignition lock in order to avoid the car being
inadvertently locked and, in addition, the anti-theft alarm system* being switched
on. Should this happen, press the unlock button of the radio remote control.
2
–
Press button A twice in 3 seconds. Further information ⇒ page 45.
•
Boot lid remote release
2
–
Press button A for about 2 second. Further information ⇒ page 48.
Folding out of the key
4
–
Press button A.
Synchonisation of the remote control
Folding up of the key
If the vehicle cannot be unlocked by actuating the remote control system then it is
possible that the code in the key and the control unit in the vehicle are no longer
synchronised. This can occur when the buttons on the radio-operated key are actu-
ated a number of times outside of the operative range of the equipment or the
battery on the remote control was replaced.
4
–
Press button A and collapse the key bit in the housing.
The turn signal lights flash twice as confirmation that the vehicle has been
unlocked. The vehicle will lock again automatically if you unlock the vehicle using