北米Model "A2650BE-A" EDITED: 2025/ 6/ 27
– When driving on a road with many
curves.
– When there are some objects that
reflect light strongly, such as a road
sign or a mirror in vehicle ahead.
– When the rear part of the vehicle
ahead, such as a container, re-
flects light strongly.
– When the headlights of your vehi-
cle are damaged or dirty.
– When your vehicle is tilted, such as
in case the vehicle has a flat tire or
is being towed.
– When the stereo camera is de-
formed or the stereo camera
lenses are dirty.
– Immediately after the engine has
started.
. In the following conditions, the head-
light mode will not be automatically
changed from the high beam to the
low beam.
– When your vehicle passes an
oncoming vehicle suddenly in a
blind curve.
– When another vehicle passes in
front of your vehicle.
– When an oncoming vehicle or
vehicle ahead comes in and out of
view because of continuous
curves, median strips, roadside
trees, etc.
. If the stereo camera detects the light
of the front fog lights of an oncoming
vehicle, the headlight mode may
change from the high beam to the low
beam automatically.
. The headlight mode may change from
the high beam to the low beam, or the
low beam mode may continue, when
affected by a street light, traffic signal,
illumination of an advertisement
board, or a reflective object such as a
road sign and signboard.
. The timing of the change of headlight
mode may differ due to the following
factors.
– Color or brightness of the head-
lights of an oncoming vehicle or the
tail lights of a vehicle ahead.
– The headlights of the oncoming
vehicle or the tail lights of the
vehicle ahead are covered with
mud, snow, etc.
– Movement and direction of an
oncoming vehicle or a vehicle
ahead.
– When the headlights of an oncom-
ing vehicle or the tail lights of a
vehicle ahead illuminate on only
one side.
– When the oncoming vehicle or
vehicle ahead is a motorcycle.
– Conditions of a road (slope, curve,
road surface, etc.).
– Number of passengers and weight
of loaded cargo.
– Limitation of the detection ability of
the stereo camera.
DAYTIME RUNNING LIGHT
SYSTEM
s03ah04
WARNING
When the daytime running lights are
illuminated, the tail lights do not
illuminate. When it becomes dark
outside, turn the light switch to the “
”
position to illuminate the headlights
and tail lights. This will improve visibi-
lity and allow other drivers to see your
vehicle more easily.
The daytime running lights will automati-
cally illuminate when the following condi-
tions are fulfilled.
. The engine is running.
. The parking brake is fully released.
. The light control switch is in “AUTO”,
“
” or “OFF”.
. The select lever is in a position other
than the “P” position.
INSTRUMENTS AND CONTROLS
218
English 
