Multivan 2025 ➤ , Multivan 2022 ➤
General body repairs, interior - Edition 09.2024
Installing
Install in reverse order of removal, observing the following:
– Pull clips -1- out of roof cross members.
– Insert clips -1- into holder -2- in direction of -arrow-.
lk
– Release vent’s freely accessible retaining clips.
On front left and front right on air duct
NOTICE
Risk of damage to air duct
– Do not drill hole too deep.
Note
Access to the retaining clip of the vent can be obtained by
drilling a hole into the air duct.
– Pre-drill hole -1- with a commercially available drill and a
3 mm drill bit, commercially available .
– Drill hole -1- with a commercially available drill and step drill
bit, commercially available to 10 mm.
Important
•
•
Make sure to maintain dimension -a- = 13 mm.
Make sure to maintain dimension -b- = 45 mm.
– Use a commercially available screwdriver to release retain‐
ing clip through hole. At the same time, remove vent from
moulded headliner.
– Cut 2 pieces of self-adhesive aluminium foil ⇒ Electronic
parts catalogue (ETKA) to size of 40 × 28 mm.
– Clean bonding surface with cleaning solution ⇒ Electronic
parts catalogue (ETKA) .
– Cover hole in air duct with self-adhesive aluminium foil
⇒ Electronic parts catalogue (ETKA) .
8. Roof trims
185
English 
