Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤ , Jetta 2011 ➤
6-Speed Manual Transmission 02Q - Edition 05.2013
2.1
Line Assembly and Bleeder on the
Clutch Slave Cylinder, Removing and
Installing
Attaching and Removing the Hose/Line Assembly and the Pipe
to or from the Bleeder
– To remove, open the clip -2- with a screwdriver or a pointed
tool and pull off hose/line assembly or pipe -4- at the bleeder
-1-.
– To install, press hose/line assembly or pipe with the new O-
ring -3- into connection of bleeder, until clip audibly engages.
– Pull on the line to make sure it is secure.
Bleeder at Clutch Slave Cylinder, Removing and Installing
– To remove, open the clip -2- with a screwdriver or a pointed
tool and remove bleeder -4- from clutch slave cylinder -1-.
– To install, check the O-ring -3- on the clutch slave cylinder.
Press in bleeder at clutch slave cylinder connector until clip
engages audibly.
– To check, pull on the bleeder.
– Bleed the clutch mechanism. Refer to
⇒ “1.10 Clutch Mechanism, Bleeding”, page 48 .
2.2
Clutch Slave Cylinder with Release
Bearing, Removing and Installing
Note
The clutch slave cylinder and the release bearing are a single unit
and are replaced together.
Removing
•
Remove the transmission.
– Open the clip -2- with a screwdriver or a pointed tool and re‐
move bleeder -4- from clutch slave cylinder -1-.
52
Rep. Gr.30 - Clutch
English 