Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤ , Jetta 2011 ➤
6-Speed Manual Transmission 02Q - Edition 05.2013
Centering the Clutch Disc, Removing and Installing the Pressure
Plate on Engines with A Crankshaft with A Smaller Diameter, or
Engines with A Needle Bearing in the Crankshaft.
Note
Ignore arrows -A and B-.
Continuation for All
– Position the pressure plate on the centering pins.
– Install all the bolts evenly, by hand, until the bolt heads contact
the pressure plate.
– Tighten the bolts in small steps and in diagonal sequence to
prevent damaging the centering holes of the pressure plate
and the centering pins of the dual mass flywheel -item 4-
⇒ Item 4 (page 66) .
– Install the transmission.
3.5
Clutch, Servicing, “LuK”
1 - Dual Mass Flywheel
❑ Removing and instal‐
ling. Refer to ⇒ Rep.
Gr. 13 .
❑ Make sure it fits secure‐
ly on the centering pins
❑ Keep the clutch lining
contact surface free of
grooves, oil and grease.
2 - Clutch Plate
❑ Allocation. Refer to the
Parts Catalog.
❑ Removing and instal‐
ling. Refer to
⇒ “3.4 LuK Clutch, Re‐
moving and Installing”,
page 62 .
❑ Only replace together
with the SAC pressure
plate
❑ Installation position. Re‐
fer to
⇒ Fig. ““Clutch Plate In‐
stalled Position”“ ,
page 63
3 - SAC Pressure Plate
❑ SAC = “Self Adjusting
Clutch”
❑ Only replace together
with the clutch plate
❑ Allocation. Refer to the
Parts Catalog.
❑ Removing and instal‐
ling. Refer to
⇒ “3.4 LuK Clutch, Re‐
moving and Installing”,
page 62 .
3. Clutch, Servicing, Diesel
65
English 
