Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤ , Jetta 2011 ➤
6-Speed Manual Transmission 02Q - Edition 05.2013
– Press the line with O-ring -3- on the bleeder connection until
the secure clip engages.
– Pull on the line to make sure it is secure.
– After removing the Hose Clamps - Up To 25mm - 3094- , bring
the return hose back to its original shape.
– Bleed the clutch mechanism. Refer to
⇒ “1.10 Clutch Mechanism, Bleeding”, page 48 .
– Install the complete air filter housing. Refer to ⇒ Rep. Gr. 23 ;
Diesel Direct Injection System; Air Filter Housing, Removing
and Installing or ⇒ Rep. Gr. 24 ; Air Filter; Air Filter Housing,
Removing and Installing .
2.4
Input Shaft Seal, Replacing
Special tools and workshop equipment required
♦ Puller - Crankshaft/Power Steering Seal - 1 - T20143/1-
♦ Seal Installer - Driveshaft - T40008-
♦ Sealing Grease - G 052 128 A1-
Procedure
•
Remove the transmission.
– Remove the clutch slave cylinder and the release bearing.
Refer to
⇒ “2.2 Clutch Slave Cylinder with Release Bearing, Removing
and Installing”, page 52 .
– Pry out input shaft seal using Puller - Crankshaft/Power Steer‐
ing Seal - 1 - T20143/1- .
Note
Be careful not to damage the contact surface for the seal on the
input shaft.
– Fill the space between the sealing and dust lip -arrow- halfway
with Sealing Grease - G 052 128 A1- .
– Lightly coat the outer circumference of the seal with transmis‐
sion fluid.
2. Clutch Release Mechanism, Servicing
55
English 
