Even if the mode automatically changes to AUTO
mode, when driving in the LOCK mode, the indi-
cator light stays in the LOCK mode.
per second). Stop the vehicle in a safe place
with the engine idling. If, after a while, the light
goes out you can continue driving.
•
4WD WARNING LIGHT
Warning light
Indication
CAUTION
Where the difference in rotation between the
front and rear wheels is large (wheel slip) - such
as when driving on rough roads through sand,
mud, or freeing a stuck vehicle - the warning
light will blink slowly (approximately once per two
seconds). Set the 4WD mode to 2WD and do
not drive fast. A large difference in diameters
between the front and rear wheels will also cause
the 4WD warning light to blink slowly. Check
that all the tyre sizes are the same, the tyre pres-
sures are correct, and that the tyres are not worn.
•
There is a malfunction in the Four-
Wheel Drive (4WD) system.
Only use the 4WD mode control when driving
in a straight direction (to select 2WD, AUTO or
LOCK).
•
m
Comes on
Do not use the 4WD mode control when turn-
ing or reversing.
•
•
The power train oil temperature is
abnormally high.
m
Do not use the 4WD mode control with the
front wheels spinning (to select 2WD, AUTO,
or LOCK).
Blinks rapidly
The difference in wheel rotation is
large.
Be especially careful when starting or driving
on slippery surfaces with the 4WD mode set
to AUTO.
•
•
CAUTION
m
If the warning light comes on or blinks while
•
Blinks slowly
driving, 4WD mode will change to 2WD mode.
Reduce the vehicle speed and have your ve-
hicle checked by a NISSAN dealer or qualified
workshop as soon as possible.
Do not drive on dry, hard surfaced roads in
the LOCK position.
The 4WD warning light is located in the tachometer.
The 4WD warning light comes on when the ignition
switch is turned to the ON position and turns off
soon after the engine is started. If the 4WD warning
light comes on, the 4WD mode indicator light will go
out.
Do not drive on dry, hard surfaced roads in
the LOCK position.
•
•
If the 4WD warning light blinks in the follow-
ing sequence while driving, proceed as in-
structed:
If the 4WD system malfunctions, or the revolution or
radius of the front and the rear wheels differ, the
warning light will either remain illuminated or blink
as follows:
–
Blinks rapidly (about twice a second)
Pull off the road at a safe place and idle the
engine. The driving mode will change to 2WD
to prevent the 4WD system from malfunction-
ing. The vehicle can be driven again as soon
as the warning light turns off.
High temperature transfer case oil makes the
warning light blink rapidly (approximately twice
•
5-26 Starting and driving
Downloaded from manuals search engine