2006-2014 Nissan Qashqai SUV Starting and driving -> Starting the engine User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Starting and driving -> Starting the engine for Your Nissan Qashqai SUV First Generation (2006-2014)

STARTING THE ENGINE  
If you failed to start the engine using the NATS Intel-  
ligent Key, turn the ignition knob to the LOCK posi-  
tion, wait for 5 seconds and turn the knob to the  
START position again to start the engine.  
1. Apply the handbrake.  
CAUTION  
2. Manual transmission models:  
Make sure you carry the Intelligent Key with  
you when operating the vehicle.  
•
•
Move the gear lever to N (Neutral) position, and  
depress the clutch pedal to the floor while start-  
ing the engine.  
If the Intelligent Key is too far away from  
the driver, the vehicle may not start.  
For additional information, see “NISSAN Anti-Theft  
System (NATS)” in the “3. Pre-driving checks and  
adjustments” section.  
Automatic transmission or Continuously vari-  
able transmission models:  
4. For diesel engine models: Wait until the glow  
indicator light goes out.  
Depress the brake pedal and move the selector  
lever to the P (Park) or N (Neutral) position.  
(P position is preferred).  
5. Crank the engine with your foot on the brake  
pedal, not on the accelerator pedal, by turning  
the ignition switch to START.  
NOTE  
6. Release the ignition switch when the engine  
starts. If the engine starts, but fails to run, repeat  
the above procedure.  
The starter is designed not to operate if the  
selector lever is out of the P (Park) or N (Neu-  
tral) position.  
For petrol engine models:  
NOTE  
3. Models without Intelligent Key:  
Rotate the steering wheel left to right to release  
the ignition lock whilst turning the ignition switch  
to the ON position.  
Models with HR16DE engine:  
If the engine is very hard to start because it is  
flooded, depress the accelerator pedal all the  
way to the floor and hold it. Crank the engine  
for 5-6 seconds and stop. After cranking the  
engine, release the accelerator pedal. Then  
crank the engine with your foot off the accel-  
erator pedal. Release the ignition switch when  
the engine starts. If the engine starts, but fails  
to run, repeat the above procedure.  
Models with Intelligent key:  
MT models  
depressed and/or depress the brake pedal  
then:  
–
keep the clutch pedal  
•
AT or CVT models – depress the brake pedal  
then:  
•
1) Push the ignition knob.  
Models with MR20DE engine:  
2) Rotate the steering wheel left to right to  
release the ignition lock whilst turning the  
ignition knob to the ON position.  
If the engine is very hard to start in extremely  
cold or hot weather, or when restarting, de-  
press the accelerator pedal a little (approxi-  
Starting and driving 5-11  
Downloaded from manuals search engine  
DRIVING THE VEHICLE  
mately 1/3 to the floor) and hold it then crank  
the engine. Release the ignition switch and  
the accelerator pedal when the engine starts.  
DRIVING WITH MANUAL  
TRANSMISSION  
CAUTION  
CAUTION  
Do not rest your foot on the clutch pedal while  
driving. This may cause clutch damage.  
•
Do not operate the starter for more than 15  
seconds at a time. If the engine does not start,  
turn the ignition switch to the “OFF” position  
and wait 10 seconds (Petrol engine models)  
or 20 seconds (Diesel engine models) before  
cranking again, otherwise the starter could be  
damaged.  
•
Stop your vehicle completely before shifting  
into the R (Reverse) position.  
•
When you are shifting from one gear to an-  
•
NSD340  
other, be certain to depress the clutch pedal  
all the way to the floor to avoid clashing or  
chipping the gears.  
5–speed MT  
If it becomes necessary to start the engine  
with a booster battery and jumper leads, the  
instructions and cautions contained in the  
“Jump-starting” in the “6. In case of  
emergency” section should be carefully fol-  
lowed.  
•
Avoid abrupt starts and acceleration for your  
safety.  
•
When quick acceleration is required for some  
•
reason, shift to a lower gear and accelerate  
until the vehicle reaches the maximum speed  
in each gear. Do not exceed the speed limit of  
any gear. Pay special attention when acceler-  
ating or when shifting into a lower gear on  
slippery surfaces. Sudden acceleration or  
down shifting could cause the wheels to skid  
and result in loss of control.  
7. Warm-up  
Allow the engine to idle for at least 30 seconds  
after starting. Drive at moderate speed for a short  
distance first, especially in cold weather.  
NSD292Z  
6–speed MT (where fitted)  
Shifting  
WARNING  
RHD models  
jA  
jB  
j1  
Do not leave the vehicle unattended while the  
engine is warming up.  
LHD models  
Gear lever ring  
To change gears, fully depress the clutch pedal,  
shift into the appropriate gear, then release the  
clutch slowly and smoothly.  
5-12 Starting and driving  
Downloaded from manuals search engine  

Related Topics

Running-in schedule Before starting the engine Precautions when starting and driving Exhaust gas (Carbon Monoxide) On-pavement and off-road driving precautions Three-way catalyst (Petrol engine models) To help prevent damage Turbocharger system (Diesel engine models) Diesel Particulate Filter (DPF) (where fitted) Regeneration restrictions If regeneration fails Care when driving Engine cold start period Loading luggage Driving on wet roads Driving under winter conditions Ignition switch Automatic transmission or Continuously variable transmission Steering lock Key positions Ignition knob (where fitted) Manual transmission Ignition knob position Emergency key ? Intelligent Key dead battery situation NISSAN Anti-Theft System (NATS) Driving the vehicle Driving with manual transmission Driving with automatic transmission or with continuously variable transmission (Models with manual shift) Driving with Continuously Variable Transmission (CVT) (Models without manual shift) Stop/Start System (where fitted) Normal operation Precautions Stop/Start System OFF switch Environmental savings Ultrasonic Parking Sensor (where fitted) Four-wheel Drive (4WD) (where fitted) 4WD mode operations 4WD shift tips 4WD Warning light 4WD Mode indicator lights Driving four-wheel drive (4WD) safely Cruise control (where fitted) Precautions on cruise control Cruise control system operations Speed limiter Speed limiter operations Parking Trailer towing Operating precautions Tyre pressure Safety chains Trailer brakes Trailer detection (where fitted) Installation of coupling device Vehicle security Power steering system Brake system Brake precautions Anti-lock Braking System (ABS) Electronic Stability Programme (ESP) system (where fitted) Electronic Stability Programme (ESP) OFF switch Cold weather driving Battery Engine coolant Tyre equipment Special winter equipment Corrosion protection

Popular Owner Manuals