SPEED LIMITER
If the vehicle slows down more than approxi-
mately 12 km/h (8 MPH) below the set speed.
The speed limiter allows you to set the desired ve-
hicle speed limit. While the speed limiter is acti-
vated, you can perform normal braking and accel-
eration, but the vehicle will not exceed the set speed.
•
Resuming a previous cruising speed
If the cruising speed has been cancelled, the set
speed value j9 will remain displayed in the combi-
nation meter and the speed will be stored in the
cruise control system memory. This cruising speed
can be reactivated by pressing the RES (Resume)
switch j1 upwards.
When the vehicle reaches the set speed limit or if
the set speed limit is lower than the actual vehicle
speed, the accelerator pedal will not work until the
vehicle speed drops below the set speed limit.
NSD373
WARNING
If the vehicle speed is less than the minimum set
speed (see table), it will not be possible to re-
sume to the cruising speed.
The speed limiter will not automatically brake
the vehicle to the set speed limit.
•
RES + (Resume) switch
SET – (Set) switch
1.
2.
3.
4.
5.
Always observe posted speed limits. Do not
set the speed above them.
•
Turn the cruise control system off
CANCEL switch
The cruise control system will be turned off when
one of the following operations is performed:
Always confirm the setting status of the speed
limiter in the combination meter display.
•
Speed limiter main “ON/OFF” switch
Cruise control main “ON/OFF” switch (For
details, see “Cruise control (where fitted)”
earlier in this section)
Push the cruise control main “ON/OFF” switch
•
When the speed limiter is set, avoid hard ac-
•
j5 . The cruise control symbol j7 , the CRUISE
indicator j6 , the SET indicator j8 , and the set
speed value j9 will turn off in the combination
meter display
celeration to reach the set limit to ensure that
the system can limit the speed of the vehicle
correctly.
The speed limiter operation switches are located on
the steering wheel (right hand side)
When additional floor mats are used, be sure
•
Push the speed limiter main “ON/OFF” switch
•
that they are correctly secured and that they
cannot interfere with the accelerator pedal.
Mats not adapted to the vehicle may prevent
proper operation of the speed limiter.
j5 . The cruise control system information in the
combination meter will be replaced with the
speed limiter information. For details see “Speed
limiter” later in this section.
When the speed limiter is on the cruise control sys-
tem cannot be operated.
When the vehicle is stopped and the ignition is
turned to the off position.
•
Turning off the cruise control system will erase
the cruise control system memory.
Starting and driving 5-31
Downloaded from manuals search engine