BRAKE SYSTEM
The brake system has two separate hydraulic cir-
cuits. If one circuit malfunctions, you will still have
braking ability with two wheels.
hill gradient. Overheated brakes may reduce brak-
ing performance and could result in loss of vehicle
control.
ANTI-LOCK BRAKING SYSTEM (ABS)
WARNING
CAUTION
BRAKE PRECAUTIONS
Vacuum assisted brake
The Anti-lock Braking System (ABS) is a so-
•
phisticated device, but it cannot prevent acci-
dents resulting from careless or dangerous
driving techniques. It can help maintain ve-
hicle control during braking on slippery sur-
faces. Remember that stopping distances
may also be longer on rough, gravel or snow
covered roads, or if you are using snow
chains. Always maintain a safe distance from
the vehicle in front of you. Ultimately, the
driver is responsible for safety.
While driving on a slippery surface, be careful
when braking, accelerating or downshifting.
Abrupt braking actions or sudden acceleration
could cause the wheels to skid and result in an
accident.
The brake booster aids braking by using engine
vacuum. If the engine stops or the drive belt is bro-
ken, you can stop the vehicle by depressing the
brake pedal. However, greater foot pressure on the
brake pedal will be required to stop the vehicle and
the stopping distance will be longer.
Be aware that brakes will fade if repeated heavy
brake applications are made.
Driving uphill
Wet brakes
When starting on a steep gradient, it is sometimes
difficult to operate the brake (AT or CVT models) or
both the brake and clutch (MT models). Use the
handbrake to hold the vehicle. Do not slip the clutch
(MT models). When ready to start, slowly release
the handbrake while depressing the accelerator
pedal and releasing the clutch (MT models) or de-
pressing the accelerator pedal (AT or CVT models).
When the vehicle is washed or driven through wa-
ter, the brakes may get wet. As a result, your brak-
ing distance will be longer and the vehicle may pull
to one side during braking.
Tyre type and condition may also affect brak-
ing effectiveness.
•
–
When replacing tyres, install the specified
size of tyres on all four wheels.
To dry brakes, drive the vehicle at a safe speed
while lightly pressing the brake pedal to heat up the
brakes. Do this until the brakes return to normal.
Avoid driving the vehicle at high speeds until the
brakes function correctly.
–
When installing a spare tyre, make sure it
is the proper size and type as specified on
the
tyre
placard.
See
“Vehicle
Driving downhill
identification” in the “9. Technical
information” section for the tyre placard
location.
The engine braking action is effective for controlling
the vehicle while descending hills.
Using the brakes
Avoid resting your foot on the brake pedal while
driving. This will overheat the brakes, wear out the
brake linings and pads faster and reduce fuel
economy performance.
–
For detailed information, see “Wheels and
tyres” in the “8. Maintenance and
do-it-yourself” section.
The gear lever (MT models) should be placed in a
gear position low enough to obtain sufficient engine
braking.
The Anti-lock Braking System (ABS) controls the
brakes so that the wheels do not lock during hard
braking or when braking on slippery surfaces. The
system detects the rotation speed at each wheel
For the AT or CVT models, a low gear position in
the manual shift mode, low enough to obtain suffi-
cient engine braking, should be selected.
To help reduce brake wear and to prevent the brakes
from overheating, reduce speed and downshift to a
lower gear before going down a slope or long down-
Starting and driving 5-39
Downloaded from manuals search engine