2006-2014 Nissan Qashqai SUV Starting and driving -> Driving with manual transmission User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Starting and driving -> Driving with manual transmission for Your Nissan Qashqai SUV First Generation (2006-2014)

DRIVING THE VEHICLE  
mately 1/3 to the floor) and hold it then crank  
the engine. Release the ignition switch and  
the accelerator pedal when the engine starts.  
DRIVING WITH MANUAL  
TRANSMISSION  
CAUTION  
CAUTION  
Do not rest your foot on the clutch pedal while  
driving. This may cause clutch damage.  
•
Do not operate the starter for more than 15  
seconds at a time. If the engine does not start,  
turn the ignition switch to the “OFF” position  
and wait 10 seconds (Petrol engine models)  
or 20 seconds (Diesel engine models) before  
cranking again, otherwise the starter could be  
damaged.  
•
Stop your vehicle completely before shifting  
into the R (Reverse) position.  
•
When you are shifting from one gear to an-  
•
NSD340  
other, be certain to depress the clutch pedal  
all the way to the floor to avoid clashing or  
chipping the gears.  
5–speed MT  
If it becomes necessary to start the engine  
with a booster battery and jumper leads, the  
instructions and cautions contained in the  
“Jump-starting” in the “6. In case of  
emergency” section should be carefully fol-  
lowed.  
•
Avoid abrupt starts and acceleration for your  
safety.  
•
When quick acceleration is required for some  
•
reason, shift to a lower gear and accelerate  
until the vehicle reaches the maximum speed  
in each gear. Do not exceed the speed limit of  
any gear. Pay special attention when acceler-  
ating or when shifting into a lower gear on  
slippery surfaces. Sudden acceleration or  
down shifting could cause the wheels to skid  
and result in loss of control.  
7. Warm-up  
Allow the engine to idle for at least 30 seconds  
after starting. Drive at moderate speed for a short  
distance first, especially in cold weather.  
NSD292Z  
6–speed MT (where fitted)  
Shifting  
WARNING  
RHD models  
jA  
jB  
j1  
Do not leave the vehicle unattended while the  
engine is warming up.  
LHD models  
Gear lever ring  
To change gears, fully depress the clutch pedal,  
shift into the appropriate gear, then release the  
clutch slowly and smoothly.  
5-12 Starting and driving  
Downloaded from manuals search engine  
To ensure smooth gear changes, fully depress the  
clutch pedal before operating the gear lever. If the  
clutch pedal is not fully depressed before the trans-  
mission is shifted, a gear noise may be heard. This  
could result in damage to the transmission.  
However, the driver remains responsible for decid-  
ing the most suitable gear according to actual ve-  
hicle, road and traffic conditions.  
NOTE  
No arrow is displayed is some circumstances in-  
cluding:  
Start the vehicle in 1st gear and shift through the  
gears in sequence according to the vehicle speed.  
–
–
The actual gear matches recommended gear  
The vehicle speed is approx. 0 km/h  
NIC1639  
Reverse gear:  
Model with Stop/Start System  
To reverse with 5–speed manual transmission,  
•
stop the vehicle and shift the gear lever into the  
N (Neutral) position then to the R (Reverse) posi-  
tion.  
To reverse with 6–speed manual transmission,  
proceed as follows:  
•
1) Stop the vehicle.  
2) Move the gear lever into the N (Neutral) posi-  
tion.  
NIC1648  
3) Pull and hold the gear lever ring j1 up.  
Model without Stop/Start System  
4) Move the gear lever into the R (Reverse) po-  
sition.  
Gear shift indicator (where fitted):  
The gear shift indicator jA located in the lower part  
of the vehicle information display can help to im-  
prove the level of environmentally friendly driving.  
5) Release the gear lever ring and safely drive  
the vehicle backwards.  
Following the gear shift indicator by changing to a  
higher (or lower) gear whenever the UP (or DOWN)  
arrow is displayed may improve fuel economy  
The gear lever ring returns to its original posi-  
tion when the gear lever is moved to the N  
(Neutral) position.  
An UP arrow suggests shifting to a higher gear, a  
down arrow suggests shifting to a lower gear.  
When the gear lever is in the R (Reverse) position,  
either the NISSAN Connect monitor (where fitted)  
Starting and driving 5-13  
Downloaded from manuals search engine  

Related Topics

Running-in schedule Before starting the engine Precautions when starting and driving Exhaust gas (Carbon Monoxide) On-pavement and off-road driving precautions Three-way catalyst (Petrol engine models) To help prevent damage Turbocharger system (Diesel engine models) Diesel Particulate Filter (DPF) (where fitted) Regeneration restrictions If regeneration fails Care when driving Engine cold start period Loading luggage Driving on wet roads Driving under winter conditions Ignition switch Automatic transmission or Continuously variable transmission Steering lock Key positions Ignition knob (where fitted) Manual transmission Ignition knob position Emergency key ? Intelligent Key dead battery situation NISSAN Anti-Theft System (NATS) Starting the engine Driving the vehicle Driving with automatic transmission or with continuously variable transmission (Models with manual shift) Driving with Continuously Variable Transmission (CVT) (Models without manual shift) Stop/Start System (where fitted) Normal operation Precautions Stop/Start System OFF switch Environmental savings Ultrasonic Parking Sensor (where fitted) Four-wheel Drive (4WD) (where fitted) 4WD mode operations 4WD shift tips 4WD Warning light 4WD Mode indicator lights Driving four-wheel drive (4WD) safely Cruise control (where fitted) Precautions on cruise control Cruise control system operations Speed limiter Speed limiter operations Parking Trailer towing Operating precautions Tyre pressure Safety chains Trailer brakes Trailer detection (where fitted) Installation of coupling device Vehicle security Power steering system Brake system Brake precautions Anti-lock Braking System (ABS) Electronic Stability Programme (ESP) system (where fitted) Electronic Stability Programme (ESP) OFF switch Cold weather driving Battery Engine coolant Tyre equipment Special winter equipment Corrosion protection

Popular Owner Manuals