Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤ , Jetta 2011 ➤
6-Speed Manual Transmission 02Q - Edition 05.2013
– Install the heat shield -1- under the selector mechanism and
attach with the lock washers -2 and 3-.
– Attach the underbody trim panel to the body -arrows-. Refer to
⇒ Body Exterior; Rep. Gr. 50 ; Underbody Trim Panels .
AWD Vehicles
– Install the driveshaft. Refer to ⇒ Rear Final Drive; Rep. Gr.
39 .
Continuation for All
– Install the exhaust system and align it without tension. Refer
to ⇒ Rep. Gr. 26 .
– Install the tunnel braces under the exhaust system. Refer to
⇒ Body Exterior; Rep. Gr. 50 ; Tunnel Brace .
– Adjust the gearshift mechanism. Refer to
⇒ “1.11 Selector Mechanism, Adjusting”, page 97 .
– If it was removed earlier install the complete air filter housing.
Refer to ⇒ Rep. Gr. 23 ; Diesel Direct Injection System; Air
Filter Housing, Removing and Installing or ⇒ Rep. Gr. 24 ; Air
Filter; Air Filter Housing, Removing and Installing .
– Complete the steps after connecting the battery. Refer to ⇒
Electrical Equipment; Rep. Gr. 27 ; Battery; Battery, Discon‐
necting and Connecting .
1.10
Gearshift Cable and Selector Cable, Re‐
moving and Installing
Removing
– Remove the selector mechanism. Refer to ⇒ page 93 .
– Bend up the tabs -arrows- on the shift mechanism base plate
using a screwdriver and remove the base plate. Only the
straps on the left side of the base plate are shown in the illus‐
tration.
– Remove the seal.
– Remove the lock washers -1 through 4-.
Note
Lock washers -1 and 4- are no longer installed in shift mecha‐
nisms beginning in 11/2006.
– Pry off the shift cable (or the selector lever cable) from the
gearshift lever (or selector lever) with a screwdriver.
– Remove the shift cable and selector cable from the shift hous‐
ing.
96
Rep. Gr.34 - Operation and Housing
English 
