Get Charging -> Battery Charger VAS5906 Guide for Audi A1 SUV 2010-2017

Audi A1 2011 ➤ , Audi A1 Sportback 2018 ➤ , Audi A2 2001 ➤ , Audi A3 20 ...

Electrical Equipment General Information - Edition 08.2019

3.4

Battery Charger - VAS5906-

⇒ “3.4.1 General Information”, page 53

⇒ “3.4.2 Battery Charger VAS5906 Device Description”,

page 54

⇒ “3.4.3 Battery, Charging with Battery Charger VAS5906 ”, page

3.4.1

General Information

WARNING

Risk of injury. Follow all warning messages and safety pre‐

cautions.

Refer

⇒ “1.3 Warnings and Safety Precautions”, page 3 .

WARNING

Do not check or charge a Battery - A- when the visual indicator

has »no color or is bright yellow«. Jump starting must not be

used!

There is a risk of explosion during testing, charging or jump

starting.

These Batteries - A- must be replaced.

Note

Observe the -VAS5906- Operating Instructions.

♦ -VAS5906- device description. Refer to

⇒ “3.4.2 Battery Charger VAS5906 Device Description”, page

54 .

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not

♦ Charge the Battery - A- . Refer to

⇒ “3.4.3 Batt^pe^er^ry^m,^ittC^edh^ua^nlerg^ssin^aug^thow^risit^eh^{d b}B^ya^AUtt^De^Ir^Ay^GC^{. A}h^UDa^Ir^Ag^Ge^dr^oV^esA^noS^t5^gu9^a0^ra6^nte”^e,^{or accept any liability}

with respect to the correctness of information in this document. Copyright by AUDI AG.

page 54 .

3. Battery, Charging

Audi A1 2011 ➤ , Audi A1 Sportback 2018 ➤ , Audi A2 2001 ➤ , Audi A3 20 ...

Electrical Equipment General Information - Edition 08.2019

3.4.2

Battery Charger - VAS5906- Device De‐

scription

-VAS5906-

The -VAS5906- was developed especially for charging the vehicle

electrical system while the vehicle is on display.

It supplies for automatic charging of 3 - 300 Ah for starter batter‐

ies.

The 14.4 V maximum charging voltage is not exceeded. All elec‐

trical consumers will be supported up to 30 A by the support

charging.

After the Battery - A- is completely charged, the -VAS5906-

switches into the maintenance charging for long-term operation.

The -VAS5906- starts automatically and does not need any ad‐

justments. Only the charging terminals and the network cable

need to be connected.

For more information. Refer to the -VAS5906- Operating Instruc‐

tions.

Control Field Overview

1 - 25% charge display

2 - 50% charge display

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not

permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability

with respect to the correctness of information in this document. Copyright by AUDI AG.

3 - 75% charge display

4 - 100% charge display

5 - Ready-to-use display

6 - Pushing the START/STOP and Setup buttons will stop and

start the charging process. Enter into the setup menu and

select characteristic line type (hold for 10 seconds)

7 - Display malfunction

3.4.3

Battery, Charging with Battery Charger

- VAS5906-

Special tools and workshop equipment required

♦ Battery Charger - VAS5906-

WARNING

Risk of injury. Follow all warning messages and safety pre‐

cautions.

Refer

⇒ “1.3 Warnings and Safety Precautions”, page 3 .

WARNING

Do not check or charge a Battery - A- when the visual indicator

has »no color or is bright yellow«. Jump starting must not be

used!

There is a risk of explosion during testing, charging or jump

starting.

These Batteries - A- must be replaced.

Rep. Gr.27 - Starter, Generator and Cruise Control

Audi A1 2011 ➤ , Audi A1 Sportback 2018 ➤ , Audi A2 2001 ➤ , Audi A3 20 ...

Electrical Equipment General Information - Edition 08.2019

Procedure

– Place the -VAS5906- in the engine compartment or under the

vehicle.

– Connect the -VAS5906- to the power supply.

The -VAS5906- is in idle, the display comes on when it is “ready

to be used”.

WARNING

Risk of injury. Follow all warning messages and safety pre‐

cautions.

Refer

⇒ “1.3 Warnings and Safety Precautions”, page 3 .

Caution

♦ Turn off the ignition and all electrical equipment.

♦ Remove the key.

– Connect the red charge terminal (+) to the positive terminal of

the Battery - A- .

Note

On vehicles with a Start/Stop function and an installed Battery

Monitoring Control Module - J367- , the black charge terminal (-)

must be connected to the body ground. The Start/Stop system

will malfunction when it is connected to the Battery - A- negative

terminal.

– C^Po^ron^ten^ce^tedct^byth^coe^pyb^rigla^htc^{. C}k^oc^pyhⁱⁿa^gr^fog^re^prit^ve^atr^em^orin^coa^ml^m(^e-^r)^cit^ao^{l p}t^uh^rpe^osn^ese^{, i}gⁿa^pati^rv^{t o}e^{r in}te^wr^hm^olein^{, is}aⁿl^ot

permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability

of the Battery - A- /negative connector.

with respect to the correctness of information in this document. Copyright by AUDI AG.

The charging process starts after approximately two seconds.

LEDs show the Battery - A- charge level. When all the lamps are

on, the Battery - A- is charged.

When the Battery - A- is completely charged, the -VAS5906- au‐

tomatically switches to maintenance charging.

Caution

Sparks can result if the charging terminals are removed too

early. End the charging process by pressing the START/STOP

button.

Battery - A- Charging, Ending

– Press the START/STOP -button.

– Remove the charging clamps from the battery terminals.

– Disconnect the -VAS5906- from the power.

3. Battery, Charging

Download User Manual App

Charging -> Battery Charger VAS5906 for Your Audi A1 SUV 2010-2017

Related Topics

Windshield Washer System

Generator, Checking

Generator

Charging

Battery, Checking

Battery

Starter, Generator and Cruise Control

Popular Owner Manuals

Latest Owner Manuals