Audi A1 2011 ➤ , Audi A1 Sportback 2018 ➤ , Audi A2 2001 ➤ , Audi A3 20 ...
Electrical Equipment General Information - Edition 08.2019
– Remove the nut -2-.
– Remove the protective cap -3-.
– Remove the bolts -4-.
– Remove the cover -1-.
– Remove the screws -3-.
– Remove the nuts -2-.
– Remove the voltage regulator -1-.
Installing
Install in the reverse order of removal while noting the following:
– When installing the voltage regulator, make sure the carbon
brushes rest correctly on the slip rings.
– Install the generator. Refer to ⇒ Electrical Equipment; Rep.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
Gr. 27 ; Generator; Generator, Removing and Installing .
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
4.19
Carbon Brushes, Checking, Hitachi
Generator
Procedure
– Remove the voltage regulator. Refer to
⇒ “4.18 Voltage Regulator, Removing and Installing - Hitachi
Generator”, page 74 .
– Check the length -a- of the carbon brushes -1-.
•
Wear limit: -a- = 6.5 mm.
– Install the voltage regulator. Refer to
⇒ “4.18 Voltage Regulator, Removing and Installing - Hitachi
Generator”, page 74 .
4. Generator
75
English 
