Audi A1 2011 ➤ , Audi A1 Sportback 2018 ➤ , Audi A2 2001 ➤ , Audi A3 20 ...
Electrical Equipment General Information - Edition 08.2019
4.12
Voltage Regulator, Removing and In‐
stalling, Valeo Generator from 2007
Special tools and workshop equipment required
♦ Feeler gauge 0.3 mm
Removing
– Remove the generator. Refer to ⇒ Electrical Equipment; Rep.
Gr. 27 ; Generator; Generator, Removing and Installing .
– Press the cover on the rear side of the generator off of the
threaded pins in direction of -arrows-.
– Remove the bolts -1- and the double bolt -2-.
– Remove voltage regulator.
Installing
– Push a feeler gauge 0.3 mm -4- between the protective cap
-2- and the carbon brushes -3-.
– Pull the protective cap off until the bar of the protective cap
presses the carbon brushes down.
– After installation of the voltage regulator, press the protective
cap all the way on.
Install in reverse order of removal, observing the following:
– Install the generator. Refer to ⇒ Electrical Equipment; Rep.
Gr. 27 ; Generator; Generator, Removing and Installing .
•
Tightening specification. Refer to
⇒ “4.9 Overview - Valeo Generator from 2001”, page 67 .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
4.13
Carbon Brushes, Checking, Valeo Gen‐
erator from 2007
Special tools and workshop equipment required
♦ Feeler gauge 0.3 mm
4. Generator
69
English 
