Audi A1 2011 ➤ , Audi A1 Sportback 2018 ➤ , Audi A2 2001 ➤ , Audi A3 20 ...
Electrical Equipment General Information - Edition 08.2019
WARNING
Do not check or charge a Battery - A- when the visual indicator
has »no color or is bright yellow«. Jump starting must not be
used!
There is a risk of explosion during testing, charging or jump
starting.
These Batteries - A- must be replaced.
2.4
Battery Test with Vehicle Diagnostic
Tester
Special tools and workshop equipment required
♦ Vehicle Diagnostic Tester
Note
The Battery - A- can also be checked while it is installed without
the connected battery charger on vehicles with Battery Monitoring
Control Module - J367- or Energy Management Control Module -
J644- and Data Bus on Board Diagnostic Interface - J533- using
the Vehicle Diagnostic Tester .
Test Prerequisites
♦ No battery charger connected
♦ Battery - A- is connected.
♦ Battery temperature at least +10 °C (50 °F).
Procedure
Vehicle Diagnostic Tester is attached.
– Select the Diagnostic mode and start the diagnostics.
– Select the tab Test Plan.
– Select Select Individual Tests and choose the following
sequence.
♦ Body
♦ Electrical Equipment
♦ 27 - Starter, voPltraotgecetedsubypcpoplyyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
♦ Electrical Compowniethnretsspect to the correctness of information in this document. Copyright by AUDI AG.
♦ A - Battery, Checking
The Vehicle Diagnostic Tester continues with the battery test from
here on.
2. Battery, Checking
11
English 
