Audi A1 2011 ➤ , Audi A1 Sportback 2018 ➤ , Audi A2 2001 ➤ , Audi A3 20 ...
Electrical Equipment General Information - Edition 08.2019
Procedure
– Remove voltage regulator. Refer to
⇒ “4.12 Voltage Regulator, Removing and Installing, Valeo
Generator from 2007”, page 69 .
– Push a feeler gauge 0.3 mm -3- between the protective cap
-2- and the carbon brushes.
– Remove the protective cap from voltage regulator -1- in direc‐
tion of -arrow-.
– Check the length -a- of the carbon brushes.
•
Wear limit: -a- = 5 mm.
– With protective cap -2- installed, use feeler gauge -4- to press
carbon brushes -3- down.
– Push the protective cap off in direction of -arrow- until the bar
of the protective cap presses the carbon brushes down.
– Install the voltage regulator. Refer to
⇒ “4.12 Voltage Regulator, Removing and Installing, Valeo
Generator from 2007”, page 69 .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
4.14
Ribbed Belt Pulley without Freewheel,
Removing and Installing
Special tools and workshop equipment required
♦ Generator Belt Socket - 3310-
®
♦
Inner hex socket 8 mm or TORX T50
70
Rep. Gr.27 - Starter, Generator and Cruise Control
English 
