Advertisement

Advertisement

Download User Manual App

Quickly access user manual for free!

Checking -> Visual Indicator Color Display, Checking for Your Audi A1 SUV 2010-2017

Audi A1 2011 ➤ , Audi A1 Sportback 2018 ➤ , Audi A2 2001 ➤ , Audi A3 20 ...  
Electrical Equipment General Information - Edition 08.2019  
♦ Damage on the battery posts. If the battery terminals are dam‐  
aged, contact with battery terminals clamps cannot be guar‐  
anteed. When connecting the battery terminal clamps, always  
keep the tightening specification for the corresponding vehicle  
from the repair manual in mind. Refer to ⇒ Electrical Equip‐  
ment; Rep. Gr. 27 ; Battery . If the battery post clamps are not  
correctly installed and secured, the wiring may burn. Substan‐  
tial malfunctions to the electrical system are a consequence.  
Safe operation of the vehicle can no longer be guaranteed.  
2.3  
Visual Indicator Color Display, Checking  
⇒ “2.3.1 3-Color Visual Indicator, Checking, through 03/2008”,  
page 9  
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not  
⇒ “2.3.2 2-Color Visual Indicator, Checking, from 04/2008”, page  
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability  
with respect to the correctness of information in this document. Copyright by AUDI AG.  
10  
2.3.1  
3-Color Visual Indicator, Checking,  
through 03/2008  
WARNING  
Risk of injury. Follow all warning messages and safety pre‐  
cautions.  
Refer  
to  
⇒ “1.3 Warnings and Safety Precautions”, page 3 .  
Visual Indicator General Information:  
The visual indicator provides information concerning the electro‐  
lyte level and the Battery - A- charge level.  
To obtain an accurate reading, gently tap the charge indicator with  
a screwdriver handle or rock vehicle slightly. By doing this, the air  
bubbles that occur normally during battery charging (even during  
vehicle operation) that adversely affect charge indicator reading  
will be displaced. Thereby, the color indicator of the visual indi‐  
cator is more accurate.  
Note  
Air bubbles can form under the visual indicator, especially if a  
Battery - A- was recharged or if the Battery - A- was charged  
while driving. These bubbles may cause the visual indicator to  
read inaccurately.  
As the charge indicator is located in a single cell, the indication  
is only valid for that cell. An exact assessment of battery con‐  
dition should always be confirmed by performing battery test.  
Refer to ⇒ “2.6.3 Battery Load Test”, page 18 .  
The visual indicator can be installed at various locations on top  
of the Battery - A- .  
There Are Three Possible Color Indications  
♦ »Green«: the Battery - A- is sufficiently charged.  
♦ »Black«: the Battery - A- is partially charged, the charge level  
is less than 65% or discharged.  
♦ »No color/bright yellow«: the Battery - A- must be replaced.  
2. Battery, Checking  
9
Audi A1 2011 ➤ , Audi A1 Sportback 2018 ➤ , Audi A2 2001 ➤ , Audi A3 20 ...  
Electrical Equipment General Information - Edition 08.2019  
WARNING  
Do not check or charge a Battery - A- when the visual indicator  
has »no color or is bright yellow«. Jump starting must not be  
used!  
There is a risk of explosion during testing, charging or jump  
starting.  
These Batteries - A- must be replaced.  
2.3.2  
2-Color Visual Indicator, Checking, from  
04/2008  
WARNING  
Risk of injury. Follow all warning messages and safety pre‐  
cautions. Refer to  
⇒ “1.3 Warnings and Safety Precautions”, page 3 .  
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not  
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability  
Visual Indicator General Information  
with respect to the correctness of information in this document. Copyright by AUDI AG.  
The »green« visual indicator for the charge level indicator is no  
longer used for these Batteries - A- . Only »black« or »no color or  
bright yellow« are used.  
The visual indicator shows the Battery - A- electrolyte level.  
It is no longer possible to read the Battery - A- charge level using  
the visual indicator. It is necessary to perform a battery test. Refer  
to ⇒ “2.6.3 Battery Load Test”, page 18 .  
To obtain an accurate reading, gently tap the charge indicator with  
a screwdriver handle or rock vehicle slightly. By doing this, the air  
bubbles that occur normally during battery charging (even during  
vehicle operation) that adversely affect charge indicator reading  
will be displaced. Thereby, the color indicator of the visual indi‐  
cator is more accurate.  
Note  
Air bubbles can form under the visual indicator, especially if a  
Battery - A- was recharged or if the Battery - A- was charged  
while driving. These bubbles may cause the visual indicator to  
read inaccurately.  
As the charge indicator is located in a single cell, the indication  
is only valid for that cell. An exact assessment of battery con‐  
dition should always be confirmed by performing battery test.  
Refer to ⇒ “2.6.3 Battery Load Test”, page 18 .  
The visual indicator can be installed at various locations on top  
of the Battery - A- .  
Two Visual Indicators Are Possible  
♦ »black«: the electrolyte level is OK  
♦ »No color or light yellow«: electrolyte level too low. Replace  
the Battery - A- .  
10  
Rep. Gr.27 - Starter, Generator and Cruise Control  

Related Topics