2024-2025 Volkswagen Multivan SUV Passengerprotection -> Removing and installing rear side airbag crash sensor [G256/G257] User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Passengerprotection -> Removing and installing rear side airbag crash sensor [G256/G257] for Your Volkswagen Multivan SUV Seventh Generation (2024-2025)

Multivan 2025 ➤ , Multivan 2022 ➤  
General body repairs, interior - Edition 09.2024  
Important  
Make sure that door forms an effective seal.  
– Connect battery earth cable ⇒ Electrical system; Rep.  
gr. 27 ; Battery; Disconnecting and connecting battery .  
CAUTION  
Pyrotechnic components can trigger unintentionally.  
Risk of injury.  
– Keep far away from pyrotechnic components when switch‐  
ing on ignition.  
– Switch on ignition.  
– Read and clear event memory using ⇒ Vehicle diagnostic  
tester.  
8.4  
Removing and installing rear side air‐  
bag crash sensor [G256/G257]  
Rear side airbag crash sensor on driver side - G256- and rear  
side airbag crash sensor on passenger side - G257- will hence‐  
forth be referred to as “crash sensor”.  
Removal and installation are described for the left side of vehi‐  
cle as an example.  
Removing  
WARNING  
Danger of airbag triggering.  
Risk of injury.  
lk  
– Check whether the airbag warning lamp lights or flashes.  
– If the airbag warning lamp lights or flashes, read out the  
event memory.  
– If there is an entry in the event memory, follow the instruc‐  
tions in Guided Fault Finding.  
– Disconnect battery earth cable ⇒ Electrical system; Rep.  
gr. 27 ; Battery; Disconnecting and connecting battery .  
– Remove side trim ⇒ Rep. gr. 70 ; Removing and installing  
side trim .  
CAUTION  
Pyrotechnic components can trigger unintentionally.  
Risk of injury.  
– Discharge any static charge by briefly touching the door  
striker plate.  
92  
Rep. gr.69 - Passenger protection  
lk  
Multivan 2025 ➤ , Multivan 2022 ➤  
General body repairs, interior - Edition 09.2024  
– Disconnect electrical connector -2-.  
– Unscrew bolt -arrow-.  
– Detach crash sensor -1-.  
Installing  
Install in reverse order of removal, observing the following:  
– Connect electrical connector until it engages audibly.  
– Make sure that electrical wire is not trapped.  
– Connect battery earth cable ⇒ Electrical system; Rep.  
gr. 27 ; Battery; Disconnecting and connecting battery .  
CAUTION  
Pyrotechnic components can trigger unintentionally.  
Risk of injury.  
– Keep far away from pyrotechnic components when switch‐  
ing on ignition.  
– Switch on ignition.  
– Read and clear event memory with ⇒ Vehicle diagnostic  
tester.  
Tightening torques  
♦ ⇒ Rep. gr. 69 ; Assembly overview – airbag crash sensors  
8.5  
Removing and installing crash sen‐  
sor for side airbag in B-pillar [G1101/  
G1102]  
Crash sensor for side airbag in B-pillar, driver side - G1101- and  
crash sensor for side airbag in B-pillar, passenger side - G1102-  
will henceforth be referred to as “crash sensor”.  
Removal and installation are described for left side of vehicle as  
an example.  
8. Airbag crash sensors  
93  

Related Topics

Safety information and repair notes Safety information Repair instructions Seat belts Assembly overview ? front three-point seat belt Assembly overview ? rear outer three-point seat belt Assembly overview ? rear centre three-point seat belt Assembly overview ? front belt buckle Assembly overview ? rear belt buckle Removing and installing front three-point seat belt [NX10]/[NX11] Removing and installing rear three-point seat belt Removing and installing front belt guide Removing and installing belt height adjuster Removing and installing front belt buckle Removing and installing rear belt buckle Airbag control unit Assembly overview ? airbag control unit Removing and installing airbag control unit [J234] Front airbag, driver side Assembly overview ? front airbag, driver side Removing and installing airbag unit with airbag igniter on driver side [N95] Renewing connector on airbag Front passenger airbag Assembly overview ? front passenger airbag Removing and installing front passenger airbag unit with igniter Removing and installing key-operated switch to deactivate airbag on front passenger side [E224] Side airbags Assembly overview ? front side airbag, outer side Assembly overview - front inner side airbag Removing and installing front side airbag, outer side Removing and installing front inner side airbag Curtain airbags Assembly overview ? curtain airbag Removing and installing curtain airbag with igniter Airbag crash sensors Assembly overview - crash sensors for airbags Removing and installing crash sensor for front airbag [G190] Removing and installing front side airbag crash sensor [G179/G180] Removing and installing crash sensor for side airbag in B-pillar [G1101/G1102] Seat occupied recognition Removing and installing front seat occupied sensor [G1067]/[G128] Removing and installing battery in control unit for wireless connection of seat occupied sensors Removing and installing rear seat occupied sensor [G1116], [G1117], [G1118], [G1119], [G1120] Removing and installing control unit for wireless connection of seat occupied sensors

Popular Owner Manuals