Download User Manual App

Quickly access user manual for free!

Driving -> Starting/switching off the engine for Your Peugeot 5008 SUV Third Generation (2024-2025)

Driving  
In some circumstances, a message indicates  
that it is necessary to turn the steering wheel  
while pressing the "START/STOP" button to  
assist unlocking of the steering column.  
By default, the system starts in Electric mode.  
Depending on certain parameters (battery  
charge level or outside temperature), the system  
determines whether it is necessary to start the  
petrol engine.  
Starting/switching off the  
engine  
The electronic key must be present in the  
passenger compartment.  
The electronic key is also detected in the  
boot.  
If the electronic key is not detected, a  
message is displayed.  
Move the electronic key so that the engine  
can be started or switched off.  
If there is still a problem, refer to the "Key  
not detected - Back-up starting or Back-up  
switch-off" section.  
Petrol engines  
It is possible to change the driving mode at any  
time using the mode selector.  
After a cold start, pre-heating the catalytic  
converter can cause noticeable engine  
vibrations, for anything up to 2 minutes  
(accelerated idle speed).  
When the vehicle starts in electric mode, it  
makes no noise.  
Pay particular attention to pedestrians and  
cyclists who may not hear the vehicle coming  
despite the pedestrian horn.  
Hybrid engines  
The vehicle always starts with the petrol  
engine to ensure the efficiency of the catalytic  
converter and the availability of the brake  
assist.  
Switching off  
After a few moments, the petrol engine may  
stop if the operating conditions allow (state  
of charge of the traction battery, external  
temperature, torque demand, selected driving  
mode).  
Immobilise the vehicle using the parking  
brake.  
Starting  
Select mode P on the automatic gearbox.  
Press the START/STOP button.  
For rechargeable hybrid vehicles, before  
leaving the vehicle, check that the READY  
indicator lamp is switched off.  
Starting rechargeable  
hybrid vehicles  
The automatic gearbox locks in mode P.  
Fully depress the brake pedal and press  
the START/STOP button for approximately 2  
seconds.  
If the vehicle is not immobilised, the  
engine will not stop.  
Keep the foot on the pedal until the READY  
indicator lamp comes on, indicating the  
activation of the rechargeable hybrid system  
(confirmed by an audible signal).  
Select mode P or N on the automatic  
With the engine off, the braking and  
steering assistance systems are also cut  
off - risk of loss of control of the vehicle!  
gearbox, then depress the brake pedal.  
Press the "START/STOP" button while  
maintaining pressure on the pedal until the  
engine starts.  
To exit Park mode, wait for the READY  
indicator lamp to come on.  
Never leave your vehicle with the  
electronic key still inside.  
In all circumstances, if one of the starting  
conditions is not met, a message is displayed.  
108  
Driving  
Starting/Switching off  
electric vehicles  
Switching on the ignition  
without starting the engine  
6
Starting  
The drive selector must be in mode P.  
Fully depress the brake pedal and briefly  
Place and hold the remote control against the  
back-up reader.  
press the START/STOP button.  
Keep the foot on the brake pedal until the  
READY indicator lamp comes on and an  
audible signal is emitted, indicating that the  
vehicle is ready to drive.  
With an automatic gearbox or a drive  
selector, select mode P, then depress the  
brake pedal.  
Press the "START/STOP" button.  
With the foot on the brake, select the mode D  
or R.  
The engine starts.  
With the electronic key in the passenger  
compartment, pressing the "START/STOP"  
button, without depressing any of the pedals,  
allows the ignition to be switched on without  
starting the engine.  
Release the brake pedal, then accelerate.  
Back-up switch-off  
On starting, the instrument panel lights up and  
the power indicator cursor moves to the "neutral"  
position. The steering column automatically  
unlocks (you may hear a sound and feel the  
steering wheel move).  
Press this button again to switch off the  
ignition and allow the vehicle to be locked.  
Switching off  
Key not detected  
Press the START/STOP button.  
Before exiting the vehicle, check that:  
– The drive selector is in mode P.  
– The READY indicator lamp is off.  
Back-up starting  
A back-up reader is fitted to the steering column,  
to enable the engine to be started if the system  
fails to detect the key in the recognition zone, or  
if the battery in the electronic key is flat.  
If the electronic key is not detected or is no  
longer in the recognition zone, a message  
appears in the instrument panel when closing a  
door or trying to switch off the engine.  
If the driver's door is opened while  
the required conditions for stopping are  
not satisfied, an audible signal is emitted,  
accompanied by the display of a warning  
message.  
To confirm the instruction to switch off the  
engine, press the "START/STOP" button for  
approximately 5 seconds.  
109