Driving
The loss of pressure detected may not
always cause visible deformation of the
tyre.
Before reinitialising the system, make sure
that the pressures of the four tyres are
correct for the conditions of use of the vehicle
and conform to the values written on the tyre
pressure label.
Check the pressures of the four tyres before
performing the reinitialisation.
The system does not advise if a pressure is
incorrect at the time of reinitialisation.
Non-standard or 'space-saver' spare
wheel
6
The use of this type of spare wheel may
suspend tyre pressure monitoring.
In this case, the malfunction warning lamp
comes on and disappears once the wheel has
been replaced by one of uniform size (the
same as the others), the pressure readjusted
and the reinitialisation carried out.
Do not rely on just a visual check.
► Using a compressor, such as the one in
the temporary puncture repair kit, check the
pressures of all four tyres when cold.
► If it is not possible to carry out this
check immediately, drive carefully at reduced
speed.
With the vehicle stationary, the sys-
tem can be reinitialised in the Set-
tings>Vehicle touch screen applica-
tion.
Driving and manoeuvring
aids - General
► In the event of a puncture, use the temporary
puncture repair kit or the spare wheel
(depending on equipment).
recommendations
► Then select Safety > Tire Pressure Setup.
► Press YES to confirm.
Driving too slowly may not ensure
optimum monitoring.
Driving and manoeuvring aids cannot, in
any circumstances, replace the need for
vigilance on the part of the driver.
The driver must comply with the Highway
Code, must remain in control of the vehicle in
all circumstances and must be able to retake
control of it at all times. The driver must adapt
the speed to climatic conditions, traffic and
the state of the road.
The alert is not immediately triggered in the
event of a sudden loss of pressure or tyre
blow-out. This is because analysis of the
values read by the wheel's speed sensors
can take several minutes.
The alert may be delayed at speeds below 25
mph (40 km/h), or when adopting a dynamic
driving style.
The reinitialisation is confirmed by the display of
a message and an audible signal.
Malfunction
In the event of a malfunction,
these warning lamps light up
on the instrument panel.
A message appears,
It is the driver's responsibility to constantly
monitor traffic conditions, assess the distance
and relative speed of other vehicles, and
anticipate their manoeuvres before using the
direction indicator and changing lanes.
These systems do not make it possible to
exceed the laws of physics.
accompanied by an audible signal.
In this case, the tyre under-inflation monitoring
function is no longer performed.
Have it checked by a PEUGEOT dealer or a
qualified workshop.
The alert is kept active until the system is
reinitialised.
Reinitialisation
The system must be reinitialised after any
adjustment to the pressure of one or more tyres,
and after changing one or more wheels.
125
English 