Multivan 2025 ➤ , Multivan 2022 ➤
General body repairs, interior - Edition 09.2024
lk
– Use removal wedge from removal wedge set - VAS 895 015-
to release clips -2-.
– Pull off roof end strip -2- far enough to gain access to electri‐
cal connector.
– Disconnect electrical connector.
– Remove roof end strip -2-.
Installing
Install in reverse order of removal, observing the following:
– Bring sealing lip of rear lid seal into installation position.
8.3
Removing and installing moulded
headliner
8.3.1
Removing and installing moulded
headliner, rear, without glass panel
Special tools and workshop equipment required
♦ 3 mm drill bit, commercially available
♦ Drill, commercially available
♦ Step drill bit, commercially available
♦ Suitable drill bit 3 mm, commercially available
♦ hook - 3370-
♦ step drill bit, commercially available
Note
The moulded headliner is removed along with the vents. The
vents can only be removed after the moulded headliner has
been removed.
The rear moulded headliner without glass panel will henceforth
be referred to as “moulded headliner”.
Removing
– Remove front moulded headliner ⇒ Rep. gr. 70 ; Removing
and installing moulded headliner .
– Release C-pillar trims ⇒ Rep. gr. 70 ; Removing and instal‐
ling C-pillar trim .
– Remove roof end strip ⇒ Rep. gr. 70 ; Removing and instal‐
ling roof end strip .
172
Rep. gr.70 - Trim, insulation
English 
