2024-2026 Lexus LBX SUV Driving -> Automatic Rear Flashing Hazard Lights User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Driving -> Automatic Rear Flashing Hazard Lights for Your Lexus LBX SUV First Generation (2024-2026)

310
4-5. Using the driving support systems
• When your vehicle cuts in front of
another vehicle
• When the following vehicle is sur-
rounded by other vehicles
• When there is a static object, such as a
guardrail or wall, around a following vehi-
cle
• When a following vehicle, which
approached your vehicle then moved
away, is approaching again
• When a following vehicle is moving away
from your vehicle
• When a following vehicle is overtaking
your vehicle
• When driving on roads with sharp bends,
consecutive curves, or uneven surfaces
• When the height of a following vehicle is
too much different from that of your vehi-
cle
● Especially in situations such as the follow-
ing, the system may operate even if it is
unlikely for a following vehicle to
approach your vehicle:
• When the sensor is misaligned due to a
strong impact to the sensor or its sur-
rounding area
• When towing with the vehicle
• When your vehicle is surrounded by
other vehicles
• When making a left/right turn and a fol-
lowing vehicle passes immediately
behind your vehicle
• When a following vehicle closely
approaches your vehicle before overtak-
ing
• When a vehicle driving in an adjacent
lane is within the detection range, such as
when your vehicle is driving on a narrow
lane road or driving on the edge of a lane
• When there are more than one vehicle
around a following vehicle
• When passing through a location with a
structure above the road (traffic sign, bill-
board, etc.)
• When there is a static object, such as a
guardrail or wall, around a following vehi-
cle
• When there is an adjacent vehicle while
on a curve
• When your vehicle cuts in front of
another vehicle
*
: If equipped
The rear side radar sensors detect fol-
lowing vehicles driving in the same
lane. If the system determines that the
possibility of a rear-end collision is
Automatic Rear Flashing
Hazard Lights
*
The Automatic Rear Flashing Haz-
ard Lights is a system that uses the
rear side radar sensors located on
the inside of the rear bumper.
When the system determines that
the possibility of a rear-end colli-
sion is high, it flashes the emer-
gency flashers rapidly to warn the
driver of the following vehicle.
WARNING
■ Cautions regarding the use of the
system
The driver is solely responsible for safe
driving. Always drive safely, taking care
to observe your surroundings. The Auto-
matic Rear Flashing Hazard Lights is an
auxiliary system that flashes the emer-
gency flashers rapidly to warn the driver
of the following vehicle when it deter-
mines that the possibility of a rear-end
collision is high. As this system may not
function to its fullest extent in certain situ-
ations, the driver’s own visual confirma-
tion of safety is necessary. Over reliance
on this function may lead to an accident
resulting death or serious injury.
■ To ensure the system can operate
properly
P.303
Automatic Rear Flashing Haz-
ard Lights operation
311
4
4-5. Using the driving support systems
Driving
high, the emergency flashers will flash
rapidly to warn the driver of the follow-
ing vehicle. Simultaneously, a message
will be displayed on the multi-informa-
tion display to notify the driver of the
approach of the following vehicle.
■ Operating conditions of Automatic
Rear Flashing Hazard Lights
When the following conditions are met, the
Automatic Rear Flashing Hazard Lights will
operate:
● The power switch is in ON.
● The shift position is in a position other
than R.
● The turn signal lever is not being oper-
ated.
● The relative speed between your vehicle
and the following vehicle is between
approximately 30 and 100 km/h (19 and
62 mph)
● Your vehicle is being driven at approxi-
mately 10 km/h (7 mph) or less or at any
speed with the brake pedal depressed.
■ The Automatic Rear Flashing Hazard
Lights will detect a vehicle when
The Automatic Rear Flashing Hazard
Lights detects the following vehicle driving
in the same lane within the detection range,
when it determines that the possibility of a
rear-end collision with it is high.
■ Situations in which the Automatic Rear
Flashing Hazard Lights cannot detect
vehicles
The Automatic Rear Flashing Hazard
Lights cannot detect the following vehicles
and other objects:
● Small motorcycles, bicycles, pedestrians,
etc.
*
● Guardrails, walls, signs, parked vehicles
and similar stationary objects
*
● Vehicles traveling in the opposite direc-
tion
● A vehicle in an adjacent lane
*
*
: Depending on the conditions, detection
of a vehicle and/or object may occur.
■ Situations in which the Automatic Rear
Flashing Hazard Lights may not operate
properly
● In the following situations, the system may
not detect a following vehicle properly:
• When the sensor is misaligned due to a
strong impact to the sensor or its sur-
rounding area
• When mud, snow, ice, a sticker, etc. is
covering the sensor or surrounding area
on the rear bumper
• When the vehicle is stopped or driving on
a wet road surface, such as in a puddle,
while in inclement weather, such as heavy
rain, snow, fog, etc.
• When driving up and down consecutive
steep inclines, such as hills, dips in the
road, etc.
• When towing with the vehicle
• When the following vehicle is not
approaching from straight behind your
vehicle
• When the following vehicle is approach-
ing from an angle
• If a vehicle suddenly cuts behind your
312
4-5. Using the driving support systems
vehicle
• When the following vehicle is sur-
rounded by other vehicles
• When there is a static object, such as a
guardrail or wall, around a following vehi-
cle
• When a bicycle carrier or other acces-
sory is installed to the rear of your vehicle
• When the height of a following vehicle is
too much different from that of your vehi-
cle
● In the following situations, the system may
operate even though there is no possibil-
ity of a collision
• When the sensor is misaligned due to a
strong impact to the sensor or its sur-
rounding area
• When towing with the vehicle
• When your vehicle is surrounded by
other vehicles
• When your vehicle is stopped to make a
turn at an intersection, etc. and a vehicle
passes your vehicle from straight behind
• When your vehicle is stopped on the
roadside, etc. and a vehicle passes close
to the side of your vehicle
• When a following vehicle closely
approaches your vehicle before overtak-
ing
• When a following vehicle suddenly
approaches to close to your vehicle
• When there is a static object, such as a
guardrail or wall, around a following vehi-
cle
*
: If equipped
Secondary Collision Brake
(Rear Impacts while
Stopped)
*
The Secondary Collision Brake
(Rear Impacts while Stopped) is a
system that uses the rear side radar
sensors located on the inside of the
rear bumper. When the system
determines that the possibility of a
rear-end collision while the vehicle
is stopped is very high, the brakes
are controlled automatically to
help reduce the possibility of fur-
ther damage due to a secondary
collision.
WARNING
■ Cautions regarding the use of the
system
The driver is solely responsible for safe
driving. Always drive safely, taking care
to observe your surroundings. The Sec-
ondary Collision Brake (Rear Impacts
while Stopped) is an auxiliary system that
controls the brakes automatically when it
determines that the possibility of a rear-
end collision with the following vehicle
driving in the same lane is very high while
the vehicle is stopped. As the Secondary
Collision Brake (Rear Impacts while
Stopped) may not function to its fullest
extent in certain situations, the driver’s
own visual confirmation of safety is nec-
essary. Over reliance on this function
may lead to an accident resulting death
or serious injury.
■ To ensure the system can operate
properly
P.303

Related Topics

Before driving Driving the vehicle Cargo and luggage Trailer towing (vehicles without towing package) Trailer towing (vehicles with towing package) Driving procedures Power (ignition) switch EV drive mode Transmission Turn signal lever Parking brake Brake Hold Operating the lights and wipers Headlight switch AHS (Adaptive High-beam System) AHB (Automatic High Beam) Fog light switch Windshield wipers and washer Rear window wiper and washer Refueling Opening the fuel tank cap Using the driving support systems Lexus Safety System + software update Lexus Safety System + Driver monitor PCS (Pre-Collision System) LTA (Lane Tracing Assist) LCA (Lane Change Assist) LDA (Lane Departure Alert) PDA (Proactive driving assist) FCTA (Front Crossing Traffic Alert) RSA (Road Sign Assist) Dynamic radar cruise control Cruise control Emergency Driving Stop System Speed limiter BSM (Blind Spot Monitor) Rear Vehicle Approaching Indication Secondary Collision Brake (Rear Impacts while Stopped) Safe Exit Assist Lexus parking assist-sensor RCTA (Rear Crossing Traffic Alert) function RCD (Rear Camera Detection) PKSB (Parking Support Brake) Parking Support Brake function (static objects front and rear of the vehicle/static objects around the vehicle) Parking Support Brake function (moving vehicles rear of the vehicle) Parking Support Brake function (pedestrians rear of the vehicle) Lexus Teammate Advanced Park GPF (Gasoline Particulate Filter) system Driving assist systems Driving tips Hybrid Electric Vehicle driving tips Winter driving tips Utility vehicle precautions

Popular Owner Manuals